... I'm not going to directly answer you question ('cuz I don't know the answer!) but I wanted to mention something else about this: If the gen-set has a small...
If I had a small 6kw genset that was to be run outside our comms trailer, how would I remotely see the fuel level? I've thought about putting a 0-10" of H2O...
Thanks Mark. I did check them and they are in where they should be. It was working for about fifteen hours before I noticed the led was red. The xtal is most...
Todd, Make sure that C15 & C16 are installed correctly. They should be installed parallel to U2 (processor). When I built mine, I got them in wrong and it...
Someone did implement that on the OpenTracker. It's not a standard option yet. Scott _____ From: tracker2@yahoogroups.com [mailto:tracker2@yahoogroups.com] On...
... Ah, ok. I had this vague memory of someone mentioning in the past that they had used the counter value as an indication of which packets hadn't been...
It's not supposed to increment with each transmission - it's suppose to increment with each counter input, and optionally reset with each transmission. No, the...
Hmm, that probably means the oscillator isn't starting properly. Check the crystal and the capacitors next to it, as well as the two resistors (100k and 10m,...
Scott; I got the OT2 put together and it workled fine all night. I just noticed that the led is now red and won't respond to anything. Unplug and plug in power...
... The NMEA ... said they ... luck so ... Sounds good. Now, a couple of more questions. :-) I have the OT2 configured to send out the counter, but the value...
Last time I checked current draw on the bench, it was 10 or 12 mA. The NMEA waypoint output should be compatible with the Avmap - someone else said they had...
Hi All: I got my Proto C board in the mail yesterday, from the last batch that was made up. After putting the tots to bed, I started soldering away, and had it...
I've added some new commands, some of which might stay in the firmware - at the moment they're just there to support my balloon launch on Saturday. SQUAWK...
Actually, it seems to be on the decoding side of findu. I followed her the next day in my car watching on the d700, and it was fine. False alarm Wes ... -- ...
If you see it again, grab the raw string, tell me what your client says the heading is, and what it should be, and I'll see if it's a problem on the encoding...
Yeah. Does Peet Bros and KISS at the same time now. Once I get the 1-wire stuff ported, you should be able to do 1-wire weather, KISS, digipeating, and...
Also, I've watched my d700 talk to the TNC... just to collect GPRMC and GPGGA, it has to constantly set the buffer to either/or. Once the data is collected...
Good points - turns out were kinda screwed on this anyway. I got a look at a Service Manual (online) last nite; and, from what I could tell (I wasn't able to...
The big holdup is the 1.5mm jumpers... I'm trying to get more from Alinco now. Scott _____ From: tracker2@yahoogroups.com [mailto:tracker2@yahoogroups.com] On...
I'm watching my wife's car move with an OT in compressed mode and the heading seems to be 180 degrees off. Anyone else noticed this? I'm not sure if it's a...
The next board rev is coming along slowly, and I know a lot of people have been wanting to join in the beta test, so I had the board house run off another...
... The commands look similar because they are the same units. My guess is that all they REALLY do is pass the inputs from the serial port ... That is where...
The firmware will definitely need addressing; but, I'm guessing that it's pretty simple, because the 'Kenwood' commands look real similar to the 'Tasco'...
