I think if you remove the WIDE1 alias it will not do a WIDE1 digi. The setting is actually calling for the digipeater to give the originator one hop. _____ ...
ok, but what about the Fill-In configuration From what I can read on this page: http://wiki.argentdata.com/index.php/Digipeater_Setup "To setup a fill-in set:...
I've got an Alinco DR-135t/T2-135 and a Byonics GPSR feeding port b, and I'm getting this cross talk noise from the speaker. If I unplug the GPSR, it goes...
Pack her bag. ve3bdr From: Greenhalgh, Christopher K. Sent: Monday, November 01, 2010 11:56 AM To: tracker2@yahoogroups.com Subject: [tracker2] DR-135 cross...
She wouldn't like riding in my car. I have the radio up just enough to hear packets. Maybe you should turn up the volume so packets can be heard as well. Of...
It's a known problem with the DR-135T. Easiest fix is to plug a blank 3.5mm plug into the speaker jack in the back. That'll shut off the speaker entirely. ...
I've asked before but still can't seem to figure out how to get the altitude information from my high altitude balloon flights to display on my Nuvi 350 /...
Hi Pete, I know I had it working on the units we used for a launch back in June - perhaps that didn't make it into the official release, I'll have to check. ...
Scott N1VG wrote... ... I resisted a reply saying "put the wife outside the car" hi! I have the same combo, but don't hear any packet "bleeding" into the...
The pinouts are listed here: https://www.argentdata.com/catalog/product_info.php?cPath=22&products_id=112 If you use the yellow and black serial + power cable,...
I've uploaded a new T2 firmware build (55502) - it's the last item on the list when you hit the 'web' button in otwincfg. This should fix problems with the...
Will this work on an OT2m and/or a T2-135 that don't have any weather work, but are connected to Nuvi 350s? Lynn (D) - KJ4ERJ - OT2m as KJ4ERJ-9 and T2-135 as...
Scott N1VG wrote... ... I loaded build 55502 into a T2-135. It seems like it decodes a few packets and then stops decoding... or doesn't decode any at all...
I just tried it out and it worked fine for hours, then I exited UI-View32 and it seemed to be locked up but still showing an RX light - a failure mode that's...
Scott N1VG wrote... ... Thanks for looking at it, although I'm not sure which of the four solutions that it is! In the meantime, the T2-135 is still ticking...
For some reason, when I run the config program under Wine in linux, the top option works, but the bottom option does not. I rebooted into XP and both worked;...
I have a Garmin Nuvi 1300 and I upgraded from firmware 54746 because waypoints never show up on the map. I have the new firmware installed and it looks like...
... I think it'd fall into the monitor category. I just included the link because it's a handy visualization to understand the sort of stuff that can go wrong...
Yes, when I click on the first item (the firmware from 9-2009) it uploads just fine. When I click on the developmental build, I get an internal application...
Scott N1VG wrote... ... I've never seen it "stop" decoding before. It was only after the upgrade to 55502, and it just did a couple of times. I was going to go...
Scott N1VG wrote... ... I just updated from 55502 to 55503. I have since enabled and disabled the T2-135 in UI-View several times and let it run 2-5 minutes...
