Guys, I have a Top 80 on a Fly products Powerjet. I was wondering, when you go full throttle, does the carb when pulled by the cable go all the way through...
Hi Ron, At least in my engine, full throttle = full open carb. Actually, my hand throttle lever still has some room left to be squeezed, but the carb end of...
Hi all, Fuel has been leaking from the joint between the carb with the flapper valves assembly. I took it off, cleaned all the original grey glue, and applied...
... Jerome, are you absolutely SURE this is where your original leak was? Such a leak risks leaning out your mixture and engine overheating! I have seen many...
Keith Pickersgill
flying@...
May 5, 2003 9:52 am
131
... Hi Ron, I do not know that particular model paramotor, but I know the Top80 engine well. The carb throttle linkage should run out of travel before the ...
Keith Pickersgill
flying@...
May 5, 2003 9:52 am
132
... Yes that's where I've seen it as well. Any way to stop that? It doesn't affect performance but it is annoying to watch that drip every 20 - 30 seconds. ...
Ron, Keith, I adjusted my cable to run out of throttle before the handle was pulled completely. What I then found was that there was a lot of engine speed...
Ok my 2 cents. There are two places on the carb where you can attach the cable connector.Two holes on the throttle arm. I use the one closer to the pivot point...
... My Miniplane came with this spring from factory, but attached to the engine block. With respect to the fuel leak, I do also have some from the mixture ...
I've had my top 80 new and running for 16 hours now. no problems other than needing to regap the spark plug to fix a little sputtering problem at max RPM....
... to plug the pressure hose in on my carb. Do I have to take the whole carb off, or is this something you can do while it's installed? It is quite simple...
we use the grey sealant (it is a polyurethane based glue) because is the only one that we test like petrol resistant,it is a Novatio glue, make in north...
again. be very carefull to seal properly the top and the low screws, sometime leaking comes THROW the screw (filetto), we change the assembling way to solve...
... As Diego suggested, I do have the special glue he uses in Italy. I import it for the maintenance of the engines over here. It really is a nice adhesive....
Diego, Why the little tubes that you sent to me are aluminum? Any particular reason? I was thinking that i could find the same kind of tube, but steel, and...
I like the original Top 80. Plus I think pilots should encourage the people that have put a lot of personal and comercial effort in the paramotor such as...
Guys, I'm needing a prop for my Top 80. What are some of my choices? Has anyone tried a composite prop? I've been looking at the Ultra-Prop site at their...
I also agree, I hope the engine is not a copy, or if it is, the original designer gave permission to do it. I am having very bad carburator leaks. I have used...
