Hi, First of all the M1 engine was build with the M72 design till 1966, not 1961. And as an information to you here is the serial number of the first type 2...
hey can you guys help me out, i'm trying to remove my rear shock assembly so i can do some work on the rear end drive unit. but seem to be having some trouble...
I always enjoy the fights in this room they are always so informative. Steve GARDEBLED GERALD <gardebledg@...> wrote: Hi, First of all the M1 engine was...
Hi, Did you remove the screw that hold the muffler ? It is also "locking" the center rod in the rear shock assembly. If you have removed it, then the problem...
thanks Gerald, yes i have the muffler bolt out, i see were it sits in a grove in the shaft. once i took it out i was hoping the rod woul'd just drop out but it...
... solocjnj and Gerald As I remember the rod only comes out the top. This makes seance if the pinch bolts loosen the rod can not fall down and out. Correct me...
Hi . I was hopping some one out there could help me with the torque spec. I can not find it any place .it's for the big center bolt . I have done this once...
well all it needed was a bit more force, it was a little dry and just hung up. i drove it out from the bottom it coul'd go either way but up is best as the...
I would love to see some pictures of that! ... From: "Christopher Jordan" To: thechangjiangexperience@yahoogroups.com Subject: [the Chang Jiang Experience] Re:...
i have opened the rear drive unit to see why my oil shows some silver glitter. looks like the input bearing on the pinion gear[driving gear part #39] is very...
yep i took some pictures of the rear shock all broken down ill get them up as soon as possible --- In thechangjiangexperience@yahoogroups.com, "Todd...
Christopher, That rod shouldn't be able to be driven out the bottom, the "cap" on top should be a permanent part of the rod that runs through the shock and it...
Hi, And after you finish tighting the flywheel, just make sure that the clearance between the flywheel and the top of the screws that hold the engine rear...
Hi, The top cap can be removed there is no problems with that. As a matter of fact whenever I remove the rod, I always removed the cap so that way when I...
Hi, The bearing should be a tighter press fit and should spin in the case as you describe it. You should be able to removed the bearings and pinion without...
Thanks, GG. ... Hi, The top cap can be removed there is no problems with that. As a matter of fact whenever I remove the rod, I always removed the cap so that...
Hi, with some good glases may be you can read the subject: 1960 CJ750 at changjiangunlimited.com This bike have the distributor onder the front cover???????? ...
Well, the bike that is refered as a 1960 CJ on changjiangunlimited.com is Beta, and Beta has the distributor under the cover. If I am wrong just send me the...
My CJ is legally referred to as a 1962 model purely for the purposes of getting it registered, but it is not an M1 and it does not have the distributor under...
Hi, Well, I am like you Phil, I do not understand Wolfgang's point, specially when the CJ said to be a 1960 has the ditributor under the cover and also what is...
Thanks Gerald. I got the pinion out and used some retaining compound on the bearing outer race and it looks pretty good now. Took some measurements and it...
