Hi Group: Does any body have a picture or diagram of how the leadscrew attaches to a Model A quickchange. I'm converting a manual lathe to a QC. Thanks Arnold...
Could you be a little more specific about what you are trying to find out? I am doing the same thing with my 9" which is the same gearbox and leadscrew. I have...
I just finished a mini hand feed Jacobs drill chuck for drilling tiny holes in the lathe. I need to drill some .040 holes and a lot of them. There are lots of ...
Years ago I had a 10k SB that came with a 10in1 toolpost.I found it to be a great toolholder for turning,knurling,boaring etc. Having read hundreds of the post...
Hello Bob! That's funny, as I was just considering making an adapter that has a through hole in it, for my little Atlas lathe, using a 1" capacity bb...
The seceret is cutting the taper to the right angle. You can dial it in with an indicator dead nuts if you have an arbor to measure off of. I had to lock my...
I've been thinking lately about my useless 6K spindle. Can it be machined to accept an R8 collet? Has anybody done this or know if it can be done. I haven't...
you might think of going this way http://www.statecollegecentral.com/metallathe/MLA21.html It would let you use 5C collets for an even greater range that R8. ...
I have just purchased a taper attachment for my 10K. The part that mounts on the back of the carriage has two locating dowels and there are no holes in the...
... locating dowels, but ... trouble of doing this? My 10EE taper attachment (not original to either of my two 10EEs) has two tapered pins and associated cap...
Heres another drill chuck project i will be making in the next few days. I do lots of production machining for my company and i always need set screw holes...
You mean the 6K collet right? Mosby West ... From: southbend10k@yahoogroups.com [mailto:southbend10k@yahoogroups.com] On Behalf Of David Smith Sent: Tuesday,...
Hello lathe enjoyers, I am new to this group, but I have been using , owning and loving lathes for 40 years now. I currently own a 13 inch South Bend lathe...
Hi There Lathe Lovers, I recently E-Mailed a message called Brand New Member, I would like to know where to find it, or if it made it here at all. Thanks in...
Here's a project i have needed for a long time. I drill a lot of setscrew holes in the small parts i make. First you turn the shaft the drill the setscrew ...
