Might be reserved for later bandswitching versions ? 73 Kees K5BCQ ... From: Bill Dumke <billd@...> To: softrock40@yahoogroups.com Date: Thu, 21 Sep...
Nice cast aluminum RF tight cases are quite expensive - often more than Tony's kits. It occured to me that there is a free source of these cases available to...
I finally finished a "production" version of a Softrock receiver. By production, I mean everything in one box with proper connectors instead of a bunch of...
Good Evening, I have now uploaded the schematics and bill of materials for the two boards that make up the v6 exciter that goes with the v6 SoftRock. The files...
Hello Group, I am using A Dell Labtop to run the softrock via Rock 1.5 software. As it turns out the Labtop has only a single channel microphone input to the...
Tony posted the other day that Plain, BLT style cases were available from Hendricks QRP Kits. I just sold the last one, and no more will be available. Thanks...
Hello, I have plans to use a softrock v7 at 50MC but i stay with a few questions - Is it possible to use the mixer at 50MC ? - How should I modify the phase...
I would like to receive digital modes. I am inputting on a Delta 44 and outputting on the on board soundcard. Somebody must have figured out how to do this...
The v6 exciter kit is now at the prototype stage with the prototype kits available around September 15. This kit design is based on design and breadboard work...
Good Morning All, All materials are now in for the prototype v6 exciter kits and the first example has been built. The first example includes the stack of a...
Good Morning All, I have created a v6 IF applications folder in the SoftRock v6.0 docs folder. The first file that has been placed in the v6 IF applications ...
I have completed building a Softrock v6.1, well almost. I did all the checks using rocky 1.5, but was not getting any signals. then when doing further testing,...
We will try this again and hope the Yahoo groups are working, this is the fourth time I send this. Below is a announcement of a new SDR single band transceiver...
Hello, I am very interested in a complet kit set (Rx+Tx+Pa). Is it still possible to place an order for the Rx and where. I am also very interessted in a TX...
So, just finished my SR30 and I've got Rocky and it going..but...I'm not sure whats going on. I move around to where I expect (and hear CW) on my 718, and I...
Hi, DC to light revisited, finally managed to extract the IF out of the Icom receiver (10khz-3.3Ghz) - I tapped from one side of a large surface mount...
Hi Tony, The exciter kit is a very exciting announcement and I have a question regarding the QSE board: is there any frequency dependent component on it? The...
I constructed a softrock 40-80 m with v 6.1 board. It appeared to work at some level for a while. I could barely get a few cw stations with less than 1:1...
G'day There has been some strong interest in using a Softrock as a digital signal processing back-end to an FT-1000/FT-1000D, connected before the 8.215MHz 2nd...
... generally run with this on at all times on the lowbands when using it in stand-alone mode". What VK6VZ meant to write: "The signal level into the modified...
EUROPEAN AMPLITUDE MODULATION AMATEUR RADIO GROUP NEW YAHOO GROUP: http://groups.yahoo.com/group/eamarg/ This is a group for licenced amateur radio operators...
Hi, Ive been thinking along the lines of a sample & hold circuit clocked at half the rate of the aparent audio bandwidth from a softrock board, thinking is...
Hi Tony, Thanks for counting me in on the exciter prototype. I was wondering do you have a crystal to cover the lower portion of the 40 meter phone band ? If...
