The source code for the driver IC used in these sockets will be posted shortly following my decision to make it a something which others could modify and make...
In the files section you find the source code for both the smart sockets and for the 2 tube clock. If you have any questions bear in mind that they will...
8
smartsockets@yahoogro...
Sep 23, 2006 9:42 am
Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the smartsockets group. File :...
I have uploaded a Filemaker Pro UDC segment editor to the files section. This creates the necessary user-defined character definitions for insertion into...
... starting ... offset ... send ... Thanks John, I've just got my free time back now my car restoration project is complete.....Just tonight i have begun...
The UDC's are now available from character 32 to 127. I will look into setting the upper limit higher. in theory it should work, but those characters above 127...
I've set the lower UDC limit to location 0, the maximum is location 125 The system needs 3 bytes of space which are located at 253,254 and 255. Each UDC takes...
Hello Jeffry, sorry for the delay in responding to your email. Yes I have a couple of sockets already built and ready to go. Because they already have the...
16
smartsockets@yahoogro...
Oct 5, 2006 9:41 pm
Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the smartsockets group. File :...
Hi Chris, The package you sent arrived the other day and I've just now had time to open it. There are a few extra parts included that you will need to instruct...
Hi, nice to hear from you again ! Well the best starting point would the smartsocket group files section. If you check the connections for the 5 pin connector...
... Hi Ken I have only unpopulated PCB's I should get in some microcontrollers too. I wish I had the time to build up more sockets but you are welcome to the...
A bugfix this time, and some clarification of the documentation. Files 'SmartV2' are the most recent files and are the only versions of useable code in the...
... Hello Chris, I've finally started to assemble the boards you shipped to me last month. I have a question about the pin sockets. Which pin sockets are...
... Ken, I used receptacles from D sockets, the kind where you get a strip of them separately. I just snipped the cable crimp bit off and bent the remaining...
...Happy new year by the way, good luck with it ! Ken, the receptacles are from Rapid Electronics, part number 22-1125 They're made by Harwin and can be veiwed...
... Yes Chris, I am mentioning it because of that discussion. That is why I didn't redefine those two chrs as they are off limits because they have special...
... Ken, Chris's boards are heaps of fun and mine worked straight out of the box without a hitch. I think they are a good way of showing off what are rare and...
... available ... first. ... That's good Ken, I was concerned that I had specified using a part made of unobtanium. I think I only have 4 boards left, and...
Chris, I finally started to populate the boards tonight (yay!) I have one question. What value is R-31? I looked through what paperwork I have and haven't...
Hello Ken, that's good news ! R31 is the anode resistor and is optional. It's optional in the sense that if you use a 170Vdc power supply then you only need to...
... Hello there, No , I haven't attempted to make any special boards just for the ZM1350. Althogh I do know of at least one member of this group who has used...
... I'm guessing that more and more people will use the ZM1350 because of the cost and availability of the 7971's. I could give a layout a try, but I've never...
