... Hello there, No , I haven't attempted to make any special boards just for the ZM1350. Althogh I do know of at least one member of this group who has used...
... I'm guessing that more and more people will use the ZM1350 because of the cost and availability of the 7971's. I could give a layout a try, but I've never...
... I would also like a set of these. I can do a pcb layout if you are too busy, Chris. That's a bummer about Zetalink. Ray is a nice guy, but he's in a hole ...
... because of ... try, ... going ... layout... ... you'd be ... hole ... Hi John, For me the biggest hurdlle isn't to do the layout but to make an accurate...
Hey Chris, If you are in fact going to have more B7971 PCBs fabbed, I'll likely buy some more from you - I'm still holding out hope that we can find enough ...
Hi Matt, Okay then I'll try to get another batch done as soon as possible. I relaid the board on Eagle lastnight, and so far I've managed to shave a quarter...
... Thanks for that Rich, I was about to order a ZM1350 because I thought that would be the best way tot est it, your test has reassured me a great deal. I...
To the people interested in a ZM1350 design pcb, could you please let me know your thoughts on the design which I have just posted in the files section 'ZM1350...
Hi Chris, Design looks fine to me! So easy to forget mounting holes, and hole for the nipple - all looks good. I prefer the compact design as you have done it....
... The layout looks great to me. The hole for the glass nipple looks small, though. I just measured one of mine - it was 0.16 inches, the hole on the layout...
... Thanks Rich, yes I should have said that the reason that there is such a large space around the nipple hole is so that i can enlarge it later, as I do with...
The order is in adn the first boards should be back within 7-10 days. I need to change the software before they arrive but that's trivial. I'll post a message...
... I ordered a full set of parts from Digikey, so I assume you'd be willing sell the blank boards? You might want to leave the connection for the keep-alive...
... willing ... Not a problem, but out of interest what values resistors did you choose for the cathodes, I haven't begun to work those values out yet. ... ...
... in ... want to ... Then I ... What I did was to make room for it knowing it would pronbably not be needed ! In the absence of a physical device to test the...
The parts list doesn't mention which 5-pin connector you use or what you use for the interconnect wires between the boards. I took a look at the Digikey...
... Hi, It doesn't matter which 5-way connectors you use, or even if you use 5-way ribbon cable, as I have done in one situation. If you buy the boards from...
... Rich, I see lots of options at Digikey. The only requirement is the 2.54mm 0.1" pin pitch, the choice of the exact type of socket is upto you and your...
This morning i received the boards for the ZM1350 smartsockets. I only glanced over them for a minute or so, but they look good. The holes for the socket pins...
Thanks to anyone patiently waiting to experiment with these boards. I am glad to say that they are in good order, and work exactly the same as the original...
Hello rich, Thanks for your interest in these devices. I can spare you just enough pins to do the job, at 8p each. 16 required per PCB. The PCB's are £2.92...
62
smartsockets@yahoogro...
Apr 7, 2007 7:07 am
Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the smartsockets group. File :...
