Hello Rod and Jane, The fuesalage is finished, the wings and everything else including all fiberglass pieces are still in box. I had seat re-upholstered in a...
Rod, What a nice invitation. I must print out this e-mail and take it with me. To show you what a tyro I am, I don't know what VMC means! I assume the V is for...
I hope to be in a position to order a SKR in the near future, however here in Australia it appears that the only fuel tanks available are the standard 60 Litre...
I hope to be in a position to order a SKR in the near future, however here in Australia it appears that the only fuel tanks available are the standard 60 Litre...
Today we have rolled her out! This happened late in evening and we just had final checks and some ground runs. Everything including CHT and oil temp was OK and...
I am getting ready to install an ICOM A200 and would like to hear from anyone who found a great location to mount the antenna. Owners of other makes say...
Larry, Tyro??? If you're not careful you'll give us all a bad rap as being educated folks, instead of just a bunch of ultralight rednecks! VMC means Visual...
Denis, we are all eagerly waiting and hope your first flight went well and without problems. Where did the first flight occur? Chuck ... From: Denis N....
Hello, I am the guy that is having trouble getting an acceptable and reliable transmission from an Icom A5 through a proprietary intercom of which I have tried...
I have the Icom A-5 and use the Sigtronics High Noise SPO 22N intercom. My headsets are also Sigtronics S-58... This combination is extremely efficient....
I mounted my antenna in the center of the rear fuselage cross member that runs between the trailing edge of the wings. I made a small plate that attaches to...
Hello Ulrich and welcome to our group. As always with new members I will encourage you to check our files, links and photos post in our web site you will found...
We are using ICOM A200 with Sigtronics intercom. As the ICOM 200 is 7 watts we found that we induced feedback when the antenna was at the rear port wing bolt...
... from ... =========================================================== I have had good results from this : I run the antenna cable thru the left front lift...
Hello Mark and welcome to our group. As always with new members I will encourage you to check our files, links and photos post in our web site you will found a...
Hi Enrique, Thank you for your advice, I am waiting for a Sigtronics SPO 22N intercom. I tried the Pilot PA200 and replaced that with an intercom carrying the...
... From: Enrique Caraballo To: skyranger@yahoogroups.com Sent: Sunday, July 03, 2005 11:48 PM Subject: Re: [skyranger] antenna I have the Icom A-5 and use the...
Hello group Regretfully, I have to sell the Skyranger kit I purchased in August 2004 due to divorce. It is set up for a 912, with all the bells and whistles. ...
Dion, Sometime back you started an informative thread regarding applying 303 Protectant to the sails for UV protection. Did you use the 303, and if so, how...
Hi Jerry, Funny you mentioned the 303 Protectant. I just finish applying 303 every were but the top of the wings reason I didn't finish them is because I...
Lexan is available if enough is ordered, below is conversation I had with suppliers Kevin Woods. ... From: Engineering&Design Plastics Ltd To: 'Kevin Woods' ...
Dion, Thank you for your quick reply. I like what you said about 303. BTW, when I used it one time on the Hiperlight I owned many moons ago, I learned it was...
dose anyone trailer there skyranger to the airfield as the tail section dose not fold for regular trailering ... From: Dion To: skyranger@yahoogroups.com Sent:...
A friend of mine bought a Skyranger with a 912S and we are looking for V speeds. Any help would be appreciated--I can make some guesses for now but we need-- ...
As always I will encourage you to check our files, links and photos post in our web site you will found a lot of SKR Information in there, do search the...
At Luftsportclub Schoenhagen we have recieved the kit for our second SKR. This plane will get a Sauer-Volkswagen engine which will be installed by Sauer. They...
im about to cover the wings and would need to dill a small 1/4 in hole in the middle of the wing tip tube to supply power to the strobes i don't have the wing...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
