opentracker : OpenTracker

Support and discussion group for the OpenTracker APRS/OpenTRAC project.

Re: Controlling PTB2 pin remotely That's for the OT1+. On the OT2m you'd use CMD POWER ON, CMD POWER OFF, or CMD PULSE xx. Scott Posted - Wed Nov 25, 2009 5:40 pm	Scott Miller n1vg Offline Send Email
Re: Controlling PTB2 pin remotely Hoping that there's a way to do it with the OT1+. Maybe with a firmware mod? I'd originally planned to send my OT2m up with my balloon but I'm leaning towards Posted - Wed Nov 25, 2009 3:33 pm	Christopher Snell cjsnell Offline Send Email
Re: Controlling PTB2 pin remotely would this work with an OT1+ or with an OT2m only?? ... From: "Scott Miller" <scott@...> To: <opentracker@yahoogroups.com> Sent: Tuesday, November 24, Posted - Wed Nov 25, 2009 3:14 pm	Mike Zwingl oe3mzc oe3mzc Offline Send Email
Re: OT1+ and Garmin GPS35-PC setup Hi Keith.. The OT+ Manual says that 2 blinking red leds indicate no GPS lock or invalid GPS data. The OT+ is currently running in fixed mode without the GPS Posted - Tue Nov 24, 2009 10:39 pm	Col Thompson - VK2CRT vk2crt Offline Send Email
Re: Controlling PTB2 pin remotely Try sending it an APRS message starting with ON or OFF. That should toggle the power control pin. Maybe. It's been a long time since I tested it. Scott Posted - Tue Nov 24, 2009 5:32 pm	Scott Miller n1vg Offline Send Email
Add opentracker to your personalized My Yahoo! page What's This?

Post message:	opentracker@yahoogroups.com
Subscribe:	opentracker-subscribe@yahoogroups.com
Unsubscribe:	opentracker-unsubscribe@yahoogroups.com
List owner:	opentracker-owner@yahoogroups.com

Questions in Games & Recreation > Hobbies & Crafts