I was told that there is/was an AD concerning the elevator bellcrank that supersedes the one in the "Mustang Group Files" from 1989 (which...
Hi I have had a near failer of this part built to my plans and have gone back to the old design and so far so good .first one lasted 40 hours new old one now...
Hi My bellcrank had the bearing rivited to one side of the arm and just a hole thru the other side . The side with the bearing flexes and alows the hole on the...
Nick, I looked up the bell crank mount AD and yours does match the new AD. It is hell when you pass the 60 years mark and thing start slipping. And you are...
This just proves the Bob did one hell of a job designing this airplane! John Haedtler ... From: Olson Date: 6/6/2008 5:18:41 PM To: mustangaero@yahoogroups.com...
Can you post a picture of what you are talking about. I had my elevator push rod get loose as the rivets started to oblong, but drilling and placing a bolt...
Hi JC What do you mean by old design? Thanks Bruce Tucker Trish crawford <johnandtrishcrawford@...> wrote: Hi My bellcrank had the bearing rivited to...
The design on the blue prints shows the old design I think. There is a supplement to the blue prints showing the new design. I thnk it is in the manual in...
There are three GIF files on the group site under Files and then Bellcrank_AD. They are scanned pages from the March 15 1989 newsletter. They are not very...
There are basically 2 changes that were made to the elevator bellcrank assembly over the years. Originally the elevator bellcrank was mounted only to the...
As a follow up to this the elevator bellcrank sides in the kits now are predrilled for the bellcrank bearing and pushrod attach points. If yours are...
Thanks. You are talking about the plate just aft of the baggage bulkhead correct? I will have a closer look at this area next week. On that note I try not...
For past two or three months, Mustang II at factory is still out for maintenance. Few days ago, I was told that it would be out for another month at least. I...
Thank you for the information Chris. I have the older bellcrank design which is in good working order and I'm compliant to the AD. So other than a good...
Sir: I'm also in Pennsylvania, central Schuylkill County; however, I just finished putting my wing back on from my recent event, and still have to complete the...
We are without power because of some storms that came through the area on Sunday. Our hours will be a bit limited as a result. If you can not reach us by...
I will come out to cable airport CCB hanger "M" , I just fines my XM-II You can be my first passenger. got 30 hours now . just put on the wheel panes wing root...
Ok so I am confused now..... The prints for PN 270.327 show in the description same as 270.302 except 1.5 dia hole. the detail for 270.326 shows an overall...
http://groups.yahoo.com/group/mustangaero/message/21923 ... From: David <websurfshop@...> To: mustangaero@yahoogroups.com Sent: Tuesday, June 10, 2008...
Anybody have the wiring diagram for a Grimes Strobe System/Power Supply # 60-1750-1 ? I've tried Customer Service to no avail. Nick...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
