Rosser, they looked better than I thought they would. I also have a black and red on ebay and I'm tuning a black and yellow with silver stripe right now. Ed, I...
Hi all, here is the new YoYo Man Freehand. No tool modification, scanned Duncan 77 for pogs and clear caps off of Duncan Balistics with no mod to the caps,...
I finally found the answer to making the tigershark a top string yoyo. Check it out here on ebay. I turned it down perfectly smooth on the insides with no ...
John,<br><br>When you mod (turn) these yoyos, do you use a lathe? If yes, what jig or chuck do you use to hold the yoyo in place while turning? Any special ...
OK, now try this, beware, because this will blow your mind. Using a TS-1, shaved the way you have it, remove all shims and "O" rings. Add another bearing and ...
I've been messing with that, I put in 2 bearings that are 2mm wide instead of the stock 3mm ones. that way I only wind up with a 4mm bearing set instead of ...
My newest project, the TS-1 shaved, shimmed, center weighted and still sporting the holographic tigershark pogs, well at least a little of them.<br>John...
What I did was to spin it in my lathe and mark it with a sharpie so I would have a perfect centered circle and then I used one of my sailmakers punches, a ...
Hi All, I am not NEARLY as accomplished as most of you are. But I'm here to give it my best shot! I'll be putting a couple of picts in my album later, so check...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
