Hi Jeremy,

Yes it was 2.0.

I have just loaded 2.1 on to my laptop at home ( not the show machine ) and then
run through the show cues and noticed that the crosshairs in the channel display
window did actually respond the way I thought and was expecting them to.

I shall try the new version on the show machine when I get to the venue and see
what happens.

Thank you

Regards
Steve Tibbits

--- In lightfactory_software@yahoogroups.com, "Jeremy Kumin" <jkumin@...> wrote:
>
> Steve, are you on V2.0. ? It reminds me a little of something I saw a month
ago which .artin addressed in 2.1. I believe
>
> Jeremy
>
>
> Sent via BlackBerry by AT&T
>
> -----Original Message-----
> From: "Steve Tibbits" <theatrel@...>
>
> Date: Mon, 13 Jul 2009 22:11:47
> To: <lightfactory_software@yahoogroups.com>
> Subject: [lightfactory_software] Moving Light Questions
>
>
> Hi All,
>
> I am hoping someone may be able to give me some insight as to whether I have
an issue or not and maybe where to look.
>
> I am in the final stages of setting up a show and appear to be having a slight
issue with the two moving mirrors and two moving head fixtures I am using.
>
> The controls from LF are fine and all works fine from that point but here is
the issue. Starting from the point where LF just opened, I setup sevel groups
for the M-heads, home, floor centre, logo on stage pros.
> I also have a m-head effect - circles which I use on the floor - audience
seating
>
> I have the following sequence for the moving heads from the start after the
system loads and the fixtures start from their 0 point :
>
> 1: logo on pros - dimmer off
> 2: MH - dimmer on
> 3: MH - dimmer off
> 4: MH - floor centre - dimmer off
> 5: MH - FX circles - dimmer on
> 6: MH - turns of the dimmer and stops the fx from running.
>
> and this is where my issue starts to occur
>
> 7: MH - logo on pros - dimmer off
> 8: MH - dimmer on
>
> The issue is that the moving heads aren't located on the logo, there seem to
have lost the reference to their 0 point which was the starting reference when I
programmed the group.
>
> This also affects the floor centre as well as the next time I trigger it the
fixtures are not positioned on the floor, which in turn throws out the fx next
time i run it.
>
> Regards
> Steve Tibbits
>