Looking for someone in the New England area willing to do some glass work on my 360 lancair. Install trim wheel etc. Thanks [Non-text portions of this message...
Hallo There is a Norwegian Lancair Homepage http://www.norskaero.com/lancair/ But it hasnt been updated for a long time (4 years) Robert ... or Sweden? ... ...
Hi Just a thought but you might try Aircraft Windshield Company 10871 klyle Street Los Alamitos, California 90720 562-430-8101 Dumb Thought, but did you call...
All you can get from Lancair is a 320 canopy. I'm working with Todd Silverman to arrange for him to make me one and I know of 2 others (counting you) that need...
Do you have any info on the Walter IV P that crashed about three weeks ago all I could find on the FAA web was typical no real Insight chippewa39539...
Building Your Money, One Stack At A Time: CHANNELING STOCKS: Capture consistent profits over and over again on stocks that trend up and down sideways within a...
Wired by Lancair. Panel is empty. Has apollo stack MX20, 80 etc., sierra flight systems an all the breakers and switchs. make offer. 1- 619-549-9606 Cost was...
I am very interested in building a IV-P or ES-P but am concerned with the number of unexplained loss of flight control accidents involving very experienced...
Joe, Here's my two cents worth. I'm a brand new ES pilot with about 400 hours of Mooney time. The ES and the IV are VERY different airplanes. The ES would...
Hello Mike: Thank you so much for your insights. I am curious why you transitioned from the Mooney to the ES. I gather from your comments on the IV that you ...
When I consider a new plane I usually give the AOPA insurance agency a call and see what their opinion is of the plane via how much they will charge me to...
Dan, By your signature block, I see you are a 360 driver. How does that stack up with your expectations? How is insurance for it? What speed do you ...
There was a thread going on safety of IV-P. I read over accidents and could see no pattern other than pilot error. How does the Legacy compare to IV-P and 360....
I have had a great time learning to fly and then putting hours on the 360. I have about 250 hours on it now over 3 years. It has been a real project meaning...
Dan, thanks for the thoughtful review. The kit I bought has the outback gear and MK II tail which the manual suggests adding the trim tab to. It also has the...
Roland What are you asking for the 320 kit? How much completed, etc/location. Jim Olson ... From: lancair320builder To: lancair@yahoogroups.com Sent:...
My 360 has the Lycoming IO 360 with Ly-con 10:1 pistons and polished and ported intakes for about 220 hp. The higher compression helps with high altitude...
My new paint job was getting banged up at the rudder cable connector and the fuselage from the wind (tied down-no hangar). I contemplated building a sleeve...
So how much of a dent will the availability of the Columbia 400 put in the prices of completed IV's and ES's? The certified airplane has a base price of only...
I'm new to flying lancairs and own a 320. It has the small tail and the small gear. I've had to land in about a 10 knot cross wind only twice, and both times...
Hello all Lancair fans: I work for Lancair in Bend, Oregon. If you have any tech questions you need answered you can e-mail me and I will do my best to answer ...
Good to see you are up here1 I am restoing a 235 that sustained nose gear collapse and subsequent engine nacell fire that burned long enough to cause damage to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
