Hello all: I need to reset my router because for some reason its not taking my password. My question is does anybody know how I can retrieve my IP address off...
Joe, on Unix, its ifconfig for interface config. I don't think you need to be root to run it if all you want is to display your current interface(s) info, you...
I agree Tony, We did tests with uncompressed (raw) audio with your scripts on node 6500 as well. Awesome would be the word I would use also. Did not share...
Death to the middle class??? From what I have read in this thread about the development and possible implementation of uncompressed audio codecs in the IRLP ...
I finally did a complete install, and I noticed, perhaps too late, that the owner of the HTTPD process should is "repeater." When I did the upgrade, the owner...
... We should be able to have it handled the same way as the RTF conversion is done, if you look at the code. My C is very limited, but I have looked through...
The packet size has been changed back to what it was (1600 bytes from 640 bytes), and the problem should be fixed. The updated imike was supposed to go into a...
You know dave I think you should take this more seriously.... Your health is a second priority I think. _____ From: ve7ltd [mailto:dcameron@...] Sent:...
... No probs, thanks for fixing it Dave. :-) As I wrote privately, I might look for a more permanent solution, the smaller packet size, ironically, would have...
... Hmm, just thinking, maybe I'll test whether Echolink can handle the larger packet. If so, I believe we have a migration strategy (and one that I can hack...
... So the "Drivetime net" on 9509 will be a goer this arvo Tony? BTW ... that was me that was unitelligible yesterday, but then I'm a bit that way most of the...
... Dave's designing the system to fall back to the lowest common denominator -- if I'm set for RAW Full-Duplex as my desired CODEC and you're set for 8K GSM...
... Well, I also proved it's possible to add as many codecs as you like to the mix some years back. I had a tweaked version of IRLP that was capable of half a...
The uncompressed audio codec has been added to every node that has their updates turned on. To activate it: As root, edit the /home/irlp/custom/environment ...
... I really need a solution similar to this also, Tony. A way to "backhaul" a node into another via a VPN or similar to have it permanently connected, even...
... Oh, it was severely busted, as only 40% of the audio would make it from IRLP to Echolink. :) I'll re-establish the link. Make sure you do an "update ...
... Looks like we're in the same boat. Uncompressed audio, or even a "split codec" setup (as in my case, 95% of the audio will be going from the node to the...
Dave, I just connected to the echo reflector and the clicking noise is present on the audio for the first second or two. I will be going up to the repeater...
I have just discovered a problem with distorted and echoing Echolink audio. I have an EchoIRLP node. The echolink audio comming my way is OK, but my echolink...
... There were some recent changes to IRLP that temporarily caused this symptom. A solution has been released. To immediately get the IRLP update, login as...
... Sounds like the same issue. Try issuing an "update files" and reconnect to Echolink. Dave fixed it in the last few hours. As for not being able to get...
... the ... Ray, I've set my nodes 4730 and 4732 for HD if you want to try another. At both of my sites, the node is hard wired to the repeater (actually at...
