The retainer pin for the front axle of my 154 slipped out last week. There isn't a locking device on the rear side to prevent it from working out. The IH...
There should be a 5/16" x 2-1/4" spring pin the retain the pivot pin. Kent ... From: dvmbrad To: ihcubloboyseries@yahoogroups.com Sent: May 02, 2004 9:06 AM ...
I tried to post this earlier, but since I am new...probably headspace and timing, it didn't make it. I have a 154 that I just discovered has (had) a...
Hello Group: 1st time I ever had this problem.. Tractor runs fine when I start out cutting the lawn, After 5 Minutes Motor seem like I am running out of gas....
You may have some valves sticking when it gets hot. Bigdog ... From: sam_sam18901 To: ihcubloboyseries@yahoogroups.com Sent: Monday, May 03, 2004 12:56 PM ...
This is without a doubt a fuel starvation problem. Pull the fuel line loose from the carb and open the shutoff on the sediment bowl ALL THE WAY WIDE OPEN(you...
i would like to know more about your 154. does it smoke or use oil? are you neg. on your price? do you have any pictures you can send me? where in ky are you...
Jeff, check your e-mail ... oil? are you neg. on your price? do you have any pictures you can send me? where in ky are you located? i am in columbia tennessee....
IF YOU HAVE DONE ALL THE THINGS YOU SAID, THEN I WOULD CHECK YOUR COIL. I HAVE A 184 THAT ACTED THIS WAY AND AFTER I REPLACED THE COIL IT RUNS FINE. EQBILL ......
... will ... in ... and ... Boy I am in Ga. does it have the IH or woods deck I am gonna buy a lo-boy this weekend if you could e-mail me pictures that would...
The radiator on my 1970 lo-boy took a "dump"....in all likelyhood it was bad when I bought the tractor back in Sept.. I need a replacement at a reasonable...
I saw one parked along the road in SE Michigan this past weekend, just out of Monroe. 154 with belly mower and blade, asking price was $3250. No three point or...
Cub Lo Boy 154 International Harvester Lawn Tractor IH 1-owner 59" Woods deck IH plow 4-cyl 1972 12 pics Item number: 2397616146 item has about 12 hours left...
I just purchased what I think is a 184 with a 60 inch belly mower. The problem is, I know nothing much about the rear end and how the pto is operating. When I...
Finally got the tractor to the point of starting it. Pushed it out of the garage, add a little gas to the tank, hit the new key (previous owner had a...
On My 154, which I've nicknamed Ole Rattler, I have the same problem. The pivot point on the lever that engages the throw-out bearing is worn. when you apply...
Ouch on the cost of the deck. I haven't started on my deck yet. Hope everything is up to par on it. Maintanence, Maintanence, Maintanence...your deck probably...
This is very good information. This means one more issue is now fixed !!!! I am going to assume the carb is causing my "if you rapidly increase the gas ... the...
Well, there is the possibility that it could be worn enough to break, It would leave you without the ability to disengage the clutch until you get it fixed....
Yes I can see it rattling around. I have the fenders off and the seat mount off as we speak. I bought this tractor around X-mas of 04. I pulled most everything...
I have a 154, on of the early ones, not sure of the year. I lost the pin/bolt that goes through the driveshaft at the flywheel. Can I just replace with a...
I just lost mine as well on a 1969 154. I simply replaced mine with a stainless steel bolt. I remembered seeing a bolt through it originally, but did not...
I have for sale a 1969 cub 154 loboy with mower and front mounted blade. It starts right up, runs very good, mows good, and is in very good condition. I live...
I have for sale a 1969 cub 154 loboy with mower and front mounted blade. It starts right up, runs very good, mows good, and is in very good condition. I live...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
