With respect I have built a DX100U some 40 years ago For a start the modulator uses KT88 valves, there is only one crystal position i cannot remember the finer...
I have three Heathkit EK-2B Receivers. Two have been assembled, one has only been partially assembled. I have one case and one original Heathkit EK-2B manual. ...
FOR SALE: VHF & UHF antennas... Rubber duck antennas for 450 MHz Band. With BNC connector. Approximately 4" long. New and have never been used. QTY 6...
Can anyone tell me if Cedar Electronics of Cheltenham. are still in operation. They are described as supplying Heathkit spares. Seem to remember the name from...
... Either it was a representative of Cedar, or maybe someone that bought their inventory, but there was a few postings about new old stock British Heath parts...
I have for trade a working SB104A Station to include the following: SB-104A Transceiver SB-604 Speaker with 1144 Power Supply SB-634 SWR/Watt Meter SB-614...
Hello, My name is Mike Beck. I am a newbie to your group, and I thank you very and much for being here. Closer to 60 than I'd like to be, I've been a fan of...
Everyone. I am sorry! Writing not being my strong suit, I think I have been misunderstood. I am only looking to obtain, "buy", the missing packages. Hence my...
I have a Heathkit AJ41 AM/FM tuner that has no AM. The FM works fine. The troubleshooting information in the manual says to check the output cable and tubes...
I have a Heathkit AJ41 AM/FM tuner that has no AM. The FM works fine. The troubleshooting information in the manual says to check the output cable and tubes...
Would like to find the part # or replacement for the iron part of solder station, had it for over 35 years and would like to keep it going. But heating element...
Hi, I'm looking for an HR-10 receiver. Does anyone have one for sale? Working, sorta-working or non-working, but no "collector" stuff, please. Donald West,...
I am in the process of rebuilding a SB-220 and need a couple of parts: 1. The 6 position terminal strip (all isolated) used to mount ALC components. The...
Hi All, I am in need of a Power transformer 54-168 for my SB-610 monitor scope. Any help on where to get one? Or anyone have a spare? Thanks, Terry in North...
Hi Don, Don't have one (sorry), but was wondering if you've had experience with them in the past? I had one as a teen in the 70's, and couldn't get rid of it...
I have for sale a VF-7401 2 meter transceiver. No manual or power supply. Unit is in working condition. Cosmetically 9 out of 10. $60.00 plus shipping. Pic's...
Hi All, Have my dx-60 on the air. And the reports vary from good audio (don't change a thing) to a muffeled audio. I am using a turner plus 2 with the preamp...
I have been buying and rebuilding HW-8 radios for about a year. Most were in need of alignment and some needed a few new parts. And then I got this one. It was...
If anyone has in PDF the assembley manual for the HM-2140 OR the A version,would you mind emailing me the manual.If not would someone kindley look up the...
Thanks to ed,ken,richard and robert I've got it all on the HM- 2140.Thats why all of us Grenn Guys stick together and help when ever need be.Thanks again to...
I am restoring an AT-1. I had the paint matched for the cabinet and it repainted but the front panel is a little rough and I would like to find some better...
FOR SALE: Heath HO-10 Monitor Scope This is a later model monitor scope that looks like new. It turns on but I couldn't get a trace, so it may be that I am...
FOR SALE: Ohmite Carbon Composition Resistor Assortment Quantity of 100 NEW (mixed 2 watt and 1 watt) carbon composition resistors. 10 ohms to 3.9 Meg. Great...
