Hi, has anyone out there got a scanned copy of an M300 electrical wiring diagram that they could email to me. I have a manual but this is missing from it. ...
I'm trying to get my head around these gadgets. Does anyone know if it's possible to run the suds pump motor at normal fixed frequency (no speed control),...
No, you'd need separate VFDs to do that. -Neil F. _____ From: harrisonlathe@yahoogroups.com [mailto:harrisonlathe@yahoogroups.com] On Behalf Of Jordan Sent: 07...
... Not off the same VFD that's running the spindle. I'm converting my L5 to a VFD at the moment. The motor was 440v only, but it's a fairly easy task to find...
I assume you are using a VFD for lack of a three phase supply. You may find that if you run the suds pump from the same VFD output that feeds spindle that it...
In the terminal box of the main motor there are links to be seen, but no info on how to change them for star or delta configuration. There's a photo in the...
Thanks chaps for the quick responses. It is because I only have single phase house supply that I am looking at VFD and other possible solutions to run the 3...
So can you identify six wires coming out of the stator? Note down which wires go where and then disconnect the six motor wires. You can then identify the...
Yes Tom, I've also put out some feelers with my closest dealers, but they are on the other side of the world! Jordan Australia ... have you tried your nearest...
I have a 5000 square foot restoration shop and heat the entire building all winter long with a used motor oil furnace. Once the furnace is paid for the cost...
ah g'day mate...... i'm here in wintry ireland.... but a nice place at this time of the year.....heating and coal fires..lovely....... jason, you could try...
Has anybody out there removed the cams out of the nose on an M300,I have unscrewed the cap head set bolt and the spring but cannot remove the recessed...
I've got my L5 completely in bits at the moment. It had to come about half way apart to slide into my new workshop, so I'm taking the opportunity to ...
Hi All, New member and first post. Can any one tell me if the M300 has a lifting point and if so where is it and what thread is it? I have to collect my M300...
Andy, you could visit my website for some general tips on moving a late model M300. http://www.anf.nildram.co.uk/workshop/index.html -Neil F. _____ From:...
Andy If it is an older model (with the controls on the headstock, then there is a M12 hole in the bed. Just need to move the carriage to balance the lathe. ...
andy, advice...best way and safest way to lift the lathe is to slip a couple of straps around the webs of the bed and lift it gently so as to find its...
Well, it appears that the 2 pics that I sent did not come through the email sys. I have uploaded them to the photos area under Cole's M300. The first is a...
