I could really use some help getting the lower gear case off. As far as I can see there are 5 socket head bolts and it looks like it's located with 2 roll pins...
Dave on my M300's that is all that holds it on. Now the gasket and "putty" on the top is holding it on. I used a rubber mallet and gently knocked it loose ...
Dumb question ..Do you have to remove the upper gear case first?From: Full Auto Mike <fullautomike@...> To: harrisonlathe@yahoogroups.com Sent: Wed,...
I just needed to remove the lower gearbox. I suspect all that is holding it on is the gasket. Just tap around the sides with the rubber mallet to get it...
Is anyone running a Harrison 13 AA on a Phase-A-Matic static converter. I've tried every combination of wiring and I can't get it to run. All I get is one...
OK, this may be the dumb question of the year But... How do you start a AA lathe? I assumed you just pulled the red Stop button out. I understand the door...
Should be a foward/reverse lever on the left end of the saddle. -Neil F. _____ From: harrisonlathe@yahoogroups.com [mailto:harrisonlathe@yahoogroups.com] On...
Whoops. Sorry David, should have said right end of saddle. -Neil. _____ From: harrisonlathe@yahoogroups.com [mailto:harrisonlathe@yahoogroups.com] On Behalf Of...
I found the problem, the foot brake was sticky and would not fully release which kills the motor. Every thing fine now, I can continue cleaning. Can you use...
This is true to a great extent. However, the gear box will become gummed up after time. I obtained a 13" M300 that the knob was chewed up because of using...
... <snip> ... Which I was under the belief is the right thing as unless you have a filter a detergent type oil ends up suspending contaminates and causes...
Well today I screwed up my courage and pulled the lower gear box. When I looked in I thought someone had lain down some nice brown linoleum. I pulled out a...
... In a bit of a follow-up, after searching in vain for anyone that did taper pins in anything less than quantities of 25 with ~£8 delivery and relying on...
"I can't believe how chips get into the places they do in such abundance. (I don't mean there were chips in the gear case, but they are everywhere else.)" I...
Good morning folks, I am new to the group and was interested in the comments regarding noisy clutches on the L6, an also oil grades. I wonder if anyone has a...
Hello Duncan, I also have an L6. The sound you describe is most likely to be the clutch assembly which is worn out. The 2 clutch plates have several holes...
Hi All, I have a Harrison M300 built in 1975. I think that the headstock needs alignment. Has anyone in this group realigned the headstock in an M300? Any help...
Hi All, I have a Harrison M300 built in 1975. I think that the headstock needs alignment. Has anyone in this group realigned the headstock in an M300? Any help...
What measurements and tests have you done with what results? Which M300 is this - there are two slightly different ones. Is it the same as the current...
All, thanks for having me as part of the user group. I've just purchased a Harrison 140. I'm a complete novice having not used a lathe since I was at schol...
Hi Chris, Thank you for your response. I have not as yet conclusively determined if it is out of alignment. I will use the "Rollie's Dad's Method." I am...
