... Thanks Brian, I did a little searching in Google and came up with this place, too. It's a couple dollars cheaper and looks like the same thing. Is it,...
Hi I am having trouble with the trim, they are leaving little tails after each trim,, .......cant find out where to adjust them properly we have an HCG 12/02...
Hi This is my first time to post. I have a new Voyager and have been having trouble with the cutter too. I design and digitize my own designs and know...
In your digitizing software, you have to program a trim. I usually digitize in Generations (love that program) and then bring it into Embird and use their one...
That's what I do. I program in the jump stitches, but the machine will not cut some of them. Anni at www.littlestorehouse.com ... digitize ... and use ... more...
This happens to me occasionally, where the machine does some of the trims and not others. I use Embird and remove all the trims and then put trims in at all...
I have experienced this problem a couple of times, and it seems to be a problem with the catcher. After it occurs, I got a catcher error message. Sandy in...
I bought mine from these folks. http://www.mescoltd.com/index.html Very nice people, I about fell over when the box came. A little thing the size of a...
My Voyager was only 2 weeks old when it stopped cutting the threads on the underside. I called Texmac and they immediately recognized the problem - the...
I had a C point error on my voyager. I contacted technical support and followed their directions. I was told to set it at 275. I cut the machine on and it...
The 275 is wrong, the setting is 270. In order to loosen the wheel trying turning it back and forth a few times, if that doesn't work, move the needles over...
How can you manually bring down the needle to check alignment? I asked before but didn't get an answer. I just don't want to mess up the timing or whatever. ...
Juli, Simply press P.FOOT. This brings down the presser foot, albeit not the needle but the end result is the same. Press P.FOOT again to raise the presser...
Hmmm, Got me on that one Juli!!! (I must admit, it's always been accurate enough for me, but I see where you're coming from). I think it's over to the techs...
Hi Juli If you manually push the needle down after lowering the pressure foot the machine goes out of syncronisiation and shows an Error on the display even...
Roberta, Sometimes it becomes difficult to turn the main shaft because the basket of the hook is bound-up (which causes a C-Point error). Make sure it's clean ...
Juli With the machine 'off', remove the black rubber plug at the back of the machine. Take your finger and slide the active needle bar (the one above the ...
My Happy machine shuld be here today or tomorrow!!! Any suggestions from anyone regarding set up and orientation to the machine would be greatly appreciated ...
Lisa, The CD-Rom for set up and installation is in the box and please view it before you even get started. Brad Lisa <lisasansouci@...> wrote: My Happy...
My machine got here yesterday. I can't wait to start to learn how to use it. I must say I am a bit overwhelmed! Looking forward to the new challenges this...
Lisa, Once you get the basics down, how to center, how to thread (and get all your tensions right), and what to do in Happy Link, you'll wonder what all the...
... (and get ... wonder what ... hesitate ... a new ... You can ... looked ... one inch ... all 12 ... back side. ... tension gauge ... machine. ... slanted, ...
I just read Juli's comment and went ahead and stitched out the test design for the 12 needle tension test. When I did that I saw that the back of my design had...
Hi John, The Tajima gauge guide for the bottom thread reads 20 to 35 - sounds as though 50 is somewhat high and would account for the top being high Brian UK ...
