Leslie and the group, You guys have been most helpful and I certainly dont want to build something that will be a mis-application. In the early years of ...
As a user of both RC and Dog training remotes I would hate to see the dog training stuff on an RC channel. Also, my Lab (Shadow) is my constant companion...
I'm set up in flaperon mode with channel 6 set to VR(E) the right slider. When the slider switch is up I get up flaps, when down I get down flaps. In the...
As there is no way to reset center on the slider, you would need to activate the left slider and with the slider in the middle of its range, get the flaps to...
I have an 8U with a campac and I have recently acquired a 9Z WC2 - is there any way I can save my 8U models from my 8U campac to my 9Z? Thanks, Jeff...
Sorry, no. The storage format is different-enough that models saved to the CamPac from an 8U cannot be used in the 9Z transmitter. You can save from an 8U...
... Thanks Bax jeff bbaxter17 <futabaowners@...> wrote: Sorry, no. The storage format is different-enough that models saved to the CamPac from an 8U...
hi to all I have a question on "spectrum" 2.4ghs modules and receivers. Has anyone out there used them with the 9Z radio and if so are they as good as the ads...
Hey All, I'm the owner of a Futaba T6XAs and a Blade CP Pro micro helicopter. I want to replace the remote that came with the heli for the 6XAS, not only for...
frank, if you receive this message please respond to my email address. _teamfutaba@..._ (mailto:teamfutaba@...) i have been un-successful at my other...
teamfutaba@...
May 3, 2007 10:47 am
2726
Futaba has not yet released their FASST 2.4 GHz spread spectrum modules yet. They are due out soon....
Frank is at Top Gun in FLA! He has his lap top with him and is checking E-mails when he has time but it might be a bit before he does. Is there anything that...
Art Pesch
apesch@...
May 3, 2007 4:34 pm
2728
thanks for the reply. i'll wait for him to return. RR ************************************** See what's free at http://www.aol.com....
teamfutaba@...
May 3, 2007 8:02 pm
2729
Wait for the Futaba version to come out the Spektrum isn't a true broad spectrium and the Futaba will be. You'll be a lot happier if you do. stagk5...
If you look at the way the Futaba system works it is constantly changing frequencies (500 times a minute) to prevent any interference the Spektrum doesn't do...
Mike, what about antennae length and orientation? Similar to spektrum, or how different? Thanks, Jeff Mike Campbell <infernalbirdman1@...> wrote: If you...
The new Futaba broad spectrum radios I have seen in my local HS have a smaller jointed antenna like the Spektrum radio on the transmitter and the receiver was...
I recently addedd a GV-1 to my Hawk pro and have it set up to use the throttle to activate it (StSw set to OFF-ON). Also have it configured to use 3 speeds (on...
Hi All, Just wondering what you think of futaba's 2.4GHz modules and receivers. Is my understanding correct that they haven't made a 9 channel module and...
The 9C and 9Z systems transmit 9 channels only when set to PCM mode. Because the Futaba FASST modules for those systems require the transmitter to be in PPM...
Stagk5, ... Correct. Actually, the 9* series are actually only a true 8 ch, with an On/Off switch function for ch 9 in PCM mode only. I've had a FAAS tx/module...
I found TM7 modules and 7 channel fasst rxs on ebay. I have two systems in my helis and I have been completely satisfied. BTW I have the TM7 TX module...
I picked up a TM-7 module and rx from the local hobby shop. The last time I looked, they were $229. eBay might be cheaper. Mine has worked great! I'm still...
PROBLEMS: 1. Using the Futaba defaults, I powered the radio and then the plane. The aileron throw on one side was twice that of the other side. I then had...
