Happy New Year to all of you! I am a lone woodturner in Mexico City...trying to establish a turners club, but have found nobody doing artistic work. So I must...
Hello Klaus! ... To you as well.... ¡Felíz año nuevo! ... (.....oder "Prosit Neujahr!" !?!) ... I don't know what types of bamboo you are speaking about,...
Entra en www. foromaderatorneada.com, está en español y hay algunos que
trabajan el policromado.Un saludo. Ricardo www.tornocanario.com ... De: Robert S...
Hi Klaus- I usually get all of my information from books or the internet. However, there is a small turing club here in charleston, SC. USA. Jen Klaus Bethke...
Hi Robert: Thanks for your early response. Your suggestions are very useful, both on the bamboo, and also on teaching. I shall save your address and be in...
Hello Klaus, The only experience I have with turning bamboo has been making pens with material designed and sold in grocery store as a bamboo cutting board. It...
Hi Ron: I am very grateful for your reply. Up til now I have been unable to find anything on bamboo turning, neither from collegues, nor Amazon.com, nor etc....
Are there ANY southern Nevada wood workers out there? If so, can you tell me if there are any woodworking clubs of any kind in southern Nevada? How hard is it...
I make a certain amount of bowls using compound mitres and i used to use a protractor but i have recently purchased a digital angle guage which simplifies...
Hello Dutch: Thanks for your message. I am a lone turner here in Mexico city, therefore no-one to exchange experiences with, much less to form a club. Last...
I am always looking for an easier and more accurate way to make things. One of those is a fixture for compound mitre cutting fixture ,,Kevin has a description...
Hi Dutch: Thanks for your reply. Since I am a bit half-witted, I have the same question as Steve: could you send me a photo of your fixture? I much appreciate...
Hello Tom: Do you have any leeds on bamboo turning? I recently saw some beautiful pieces at an open market in California. I have plenty of bamboo in my...
I do not have a picture of the fixture but i will take some and post them this afternoon or tomorrow. I do not have any equipment in my home but i work with a...
Hi to all of you who are interested in the fixture i made for cutting. I know you all would like a pictures but those i took were not to good. I am going to...
Hi Dutch. Don’t worry about that now. Good luck with the Hospital, hope all goes well!!:-) Russell Hi to all of you who are interested in the fixture i made...
The more I work in the shop, because of cold weather the more my scraps build up. I have boards that I rip and slice for segmentation, but I also slice some of...
Turn-On! Chicago 2008 Woodturning Symposium July 25-28, 2008 Mundelein, IL The Chicago Woodturners present Turn-On! Chicago 2008, a woodturning symposium...
Busy cutting and glueing red elm segmented bowls. I have made several drawings and using a few choices for smaller turnings. Most of these are 6-7" wide at...
Hi George, Interesting question you raise. I'm such a creature of habit in some respects that I've never given it much thought until you mentioned it here. I...
Woodturners of Olympia will be hosting their second Woodturners symposium on July 26th. So, if you are going to be in Western Washington State around that time...
HELLO ALL: I AM FROM THE WEST COAST PITTSBURG CALIFORNIA. MY SCULPTURE PIECES ARE MOSTLY COOPERED AND PATTERNED. LATER I WILL SEND PHOTOS AS THINGS ARE PRITTY...
