Mick I also saw a demo where the demonstrator did the same. I only sharpen my scrapers and skews with a diamond file. If my maths is correct take a 12" bowl...
Hello, I am a beginning woodturing from east Texas interested in doing segmented projects. I used Segmented Project Planner to design a simple 5 layer...
Thanks for joining Ray. You will need a zero clearance back fence for your new miter saw. This will reduce snaping or pinging of small pieces. A fence for each...
where in E. TX.? There is a great woodturning group that meets in Tyler the 2nd sat. of each month. I think... Nancy D. "You are not what you were born, but...
Ray, Welcome to the group--The zero clerance backstop is the best item for your miter saw-then the next best item is your stop block for repeat segment ...
In a message dated 12/6/2005 10:52:23 A.M. Central Standard Time, swordvisions@... writes: I live just south of Carthage Texas in a little town called...
here is a forwarding of our ET newsletter and more about the group. Joseph says :The newsletter is now available. www.easttexaswoodturners.org Tom Crosby 903...
george could you please remove my old profiles i dont seem to beable to do this. I have two on this group. My new one to keep is sootsweeper, The other two are...
It's done now. Now you can tell us about some of your new projects. GT ... to do this. I have two on this group. ... My new email is as above. Look forward to...
hello my name joe i was wondering if any one has ever started there own busnisse and if so can you help me with it im trying to start a wood turning...
Joseph, where are you located? Maybe someone closer to you would be best to help you. I have started and ran my own business (although not a cabinet shop)...
http://www.sba.gov/starting_business/ The sba has some basic info, at the above link. and there is a lot of info avalible both on the internet, and from books....
thank you scott and larry i live in philadelphia pa but thanks for the info There are 2 messages in this issue. Topics in this digest: 1. Re: starting...
I'm new to turning and the group, My name is John Patrick, I sell birdfeeders, bird houses, and heated bird baths online. I'm working on turning bird house...
Joseph, You should be able to find a few classes offered on how to start a business by calling your local chamber of commerce. There are also some good...
John, WELCOME to the group.I know you can find an answer, to just about any turning question that may ever come up, from this group of GREAT individuals.It is...
Well, I finally finished my bowl. I put it in an album 'MattS' I think it turned out pretty good for my first segmented bowl. I had a little bit of a divot on...
I have nothing to show yet. The birdfeeders I sell are from a distributer. here's my web site. www.birdoasis.com or ebay: http://stores.ebay.com/Bird-Oasis/ ...
Matt, for your first segmented bowl it did turn out very nice. Bob W __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo!...
The vase was picked up this morning. The wood cost me about $50 and I spent maybe 10 hours both turning and finishing the vase (an estimate from my wife)....
Hi All, I have glued up walnut and maple pieces matching the grain direction and have turned a bowl. The problem is always the same, how do I get the end...
Have you already taken the work off the lathe? Endgrain problems come from breaking of the fibers instead of cutting them. The best solution is a sharp edge...
