Or purchase your own copy of the plans for the Spad pads from NARTS! www.nar.org/narts and click on the link to the online catalog, under Technical Equipment...
In a message dated 5/1/06 8:55:00 A.M. Eastern Daylight Time, flyemhighest@... writes: Or purchase your own copy of the plans for the Spad pads from...
... NARTS! www.nar.org/narts and click on the link to the online catalog, under Technical Equipment Reports. At the same time, see all the New Products,...
In a message dated 5/2/06 9:27:23 A.M. Eastern Daylight Time, artupton@... writes: Well Tom sucked me in. The plans were only $2, but the shipping was ...
Can record attempts be made anytime at a section launch or not???? 17.1 Sanctioned Competition All United States Model Rocket Performance Records must be...
... Hi jeff, I'm trying to be clear here. ... if your section launch is a sanctioned competition that has a sanction from your regional contest board director...
So I can make a record attempt at a club launch (not competition) this weekend? Jeff ... From: Dan Winings To: contestRoc@yahoogroups.com Sent: Thursday, May...
Uhm sorry I read that too quick, only if it is sanctioned as a Record Trials, you can do that through your Regional Contest Board. Actually it not a bad idea...
Let me clarify a little bit. You can sanction any club launch as a Records Trial. Some Clubs do. It not a competition because you don't have specific events...
... established, or surpassed during competition sanctioned by the National Association of Rocketry in accordance with this United States Model Rocket Sporting...
You can have your club launch sanctioned as a record trial. Contact your regional contest director. Check the NAR site http://nar.org/NARadmin.html way at...
Since we've been discussing Record Trials, now seems a good time to announce that the Texas Competition Consortium is sponsoring a Record Trial at NSL 2006. ...
Does anyone know a source for the thin (1/4 mil or close to it) adhesive mylar sheets like the ones that CMR used to sell way back when? TIA. -- Jeff...
jeff: without knowing what your intended use is would this work: http://www.bare-metal.com/bare-metal/bare-metal_foil.html or perhaps some 1/4 mil mylar with a...
In a message dated 5/8/06 2:53:45 P.M. Eastern Daylight Time, shockwaveriderz@... writes: jeff: here are the thicknesses for various types of Reynolds...
I have never found anything that even comes close, including trim monocote. Sure wish I could remember where Howard got it from. "Aluminized Products" or...
... Does anyone know a source for the thin (1/4 mil or close to it) adhesive mylar sheets like the ones that CMR used to sell way back when? TIA. <<<<< Ed...
For parachutes etc, I use editing tape for audio and video tape. Unfortunately, it's getting harder and harder to find as well JHB On Mon, 08 May 2006 21:01:12...
In a message dated 5/8/06 8:09:58 P.M. Eastern Daylight Time, dan.winings@... writes: I have never found anything that even comes close, including trim...
dave: I spoke with Howard on the telephone last year. hes about 84-5 and was in poor health and hard of hearing(at least via the telephone)and his wife is also...
... I've been looking for the same thing since becoming a BAR several years ago. My current supply is just about to be exhausted. Pursley told me most any...
Regardless of prototype or complexity, it is helpful to the judges to point out anything unique about your model. Hand-turned parts, non-commercial tubes, and...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
