Hi I sold my CM 21 back in 1989-1991 I can't remember the year exactly but it was for $1300. It was sitting in this guys backyard with a couple other boats in...
Hi The other poster is right you're probably not leaking at the hinge of the keel. My old 21's keel had come down hard and smashed the fiberglass at the front...
Hello Thank You. I do however have a feeling the boat is a little heavier that that. Rick _____ From: cmoa@yahoogroups.com [mailto:cmoa@yahoogroups.com] On...
Try the link below, they have reproduced the complete manual for clipper 21, http://www.scbiz.net/jcox/manual.htm Michael ________________________________ ...
Hello You are correct. Rick _____ From: cmoa@yahoogroups.com [mailto:cmoa@yahoogroups.com] On Behalf Of bnksmith Sent: Thursday, November 30, 2006 8:05 AM To:...
A little bit off thread but....Michael (Tunny) I may be looking at a Clipper 21 this week....is there anything I should be on the lookout for? I've directed...
inspect the keel, where it pivots, be sure it is sealed there. check for all the other usual items (i.e. the hull for cracks, blisters, around the keel for...
Hi Pat, I agree with Craig entirely, the only other problem I have encountered is in the V Berth, the previous owner installed a vent above the berth and water...
Hi The CM 21 is a very good boat. I have a lot of time in this boat and am fixing to restore it again. Rick ... From: Michael Tunny To: cmoa@yahoogroups.com ...
A problem I had with my 21 was the keel had been allowed to swing down hard and it smushed the fiberglass where it stopped. I was able to repair it though. ...
the swing keel on my clipper 21' is hitting the back of my trailer as i putting it in the water. saturday, i used my ford ranger to haul the boat, but i could...
Hello Do you still have the original winch supplied with the boat that has the handle inserted through a hole near the cabin entance? My boat has a winch...
hello rick, thank you for your quick response, i do still have the original set up, but i don't remember if i ever looked to see if part of the keel was...
I have a CM 26. It's keel is always out a little. I'll measure how much tomorrow if you think this could help you. It might be different as they are different...
thank you rod, thats the info i needed. ... upand is flush with the bottom of the boat Rod. ... has ... has ... keel ... trailer as ... haul the ... tried to ...
In either case I would think your cable has stretched or the clamps holding it have allowed it to slip a little. If you get it off the trailer and the cable...
thanks again rick, i will make the repairs before launching the boat again. unless the cable looks perfect, i will just go ahead and replace it too. Rick...
thanks again rick, i will make the repairs before launching the boat again. unless the cable looks perfect, i will just go ahead and replace it too. Rick...
Hi all, on my CM21 I had a grooved pad on the center of the trailer which I used to let the keel down to rest when transporting. I think if you're not letting...
I must say I almost learned the hard way about this. I was trying to come about in 7 ft swells in Santa Monica Bay and but I kept trying to Gybe by accident....
Hi to all - I also have a CM 26, which now needs a mast because a tree fell on my boat in a recent windstorm. Anybody have a '26 they are "parting Out" that...
Kathryn & Ralph McLin
rmclin@...
Feb 5, 2007 6:40 am
390
thank you for your response, ironically i was just told of a clipper out in the middle of the nevada desert (a small ghost town). the story i got on it was...
Guys, I see lots of posts about the keel always hanging below the hull. I can undserstand trying to raise it up higher, but the strain on the cable and the...
Yes, I would be interested in getting more info - and would be glad to make any calls or emails if you came up with a name (a long shot perhaps). Thanks much,...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
