Watts let's back up a bit. The clutch cams are the donut shaped rings that have a ball bearing pressed into the center and slots for the clutch fork that is...
This may be a rather lengthy post. I will be uploading, or have uploaded, pictures of an "Orchard Sprayer" that I have just acquired for my Ingersoll 448...
I just got my kawasaki conversion working in my 446 this weekend. I thought I might share one of the issues that I had in case someone else has the same...
Shannon, I don't know if you have the Case kit which should have all the fittings but if you don't here's what I suggest. Review the schematic diagram...
-- I wish I had One to go with my 91 4020 tiller plow snow blower LOL - In casegardentractors@yahoogroups.com, "Jim Eggerth" <jeggerth@...> ... for your 446....
Your photo format is fine. Since a few months ago Yahoo now automaticaly resizes all photo files when they are uploaded to conserve storage space. Moderator ...
Hi, I'm new to the board--got a 1981 Case 448 with the 18hp Onan engine that I just went through (scattered a rod). I have the tractor back together and I'm...
bart, thank you and larry (man what a wealth of knowledge he is) for the information. I am certain that I have all of the parts necessary now I just need to...
I have a new muffler for sale for an Onan engine. I bought it for my 446, but the engine is dead, and I will eventually replace it with the Kawasaki repower. ...
by injectors, I assume you mean nozzles, most of those items are pretty standard across the board, Spraying Systems Company markets a full line of this sort...
I've always wondered about the 10 ton rating on the Ingersoll log splitters, we carry a line of stand alone hydraulic wood splitters at work, 6.5 hp. engine,...
just wanted to say thanks to all for the postings on the splitter.and i mean "all" the postings.pros and cons.it's in the garage and waiting.it is a mod#j32.i...
Hi folks, I recently reposessed my case446 after my small engine mechanic had it for 2 years after the engine blew on it. To make this short I picked up the...
judging by the weight and length i am thinking i may need to counter weight the front especially when transporting.(its a 3-point hook up).has anyone had any...
Greetings, I have been a Simplicity nut all my life, but have turned now towards my first Case. Over the weekend, I picked up a 448 project tractor from one of...
Are you certain that the govenor was put back together correctly ? If the post on the timing cover cap doesn't get put in the plastic bushing on the timing...
Case made two different rotation snowblowers.. The original ones were left hand rotation and the later ones .. Late 80's I think , were right hand rotation.. ...
The Case splitter must be under rated or the other splitter manufacturers are overating theirs. . To acheive the type of performance that owners report with a...
2000 PSI of pressure on a 4 inch diameter cylinder will produce 25000 pounds of thrust. Or 12.5 tons. So to get 25 tons of thrust the others would have to...
Where are you located? I am about to strip out a 226 and likely have everything that you would need. I don't understand the "clutch wire." That sounds like an...
Welcome to the group, Grummy, Simplicity tractors are fine units and enjoy an excellent reputation for quality. Before embarking on your project, you should...
I am stripping out an Ingersoll 220 that has a factory installed holding valve and rear pto, in good working order. This is not the integral "holding-speed...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
