Is the an easy way to adjust the amount of co2 in the soda? I have plenty of gas, but the soda comes out flat. In case it matters I am using an external 5 lb...
Sounds like your tank is running low, that would cause a low carbonated soda. I set my regulator to 100psi. Breakmate has an internal regulator set to 75psi. ...
Increasing the carbonation pressure is not an easy task. It involves removing the regulator from the machine. I have never needed to do this for any of my...
I have one and will set it to 100 psi. It didn't seem to matter what I set it at the Co2 content seemed to be the same. Now I have a bigger problem water...
The gray connector is the probe connector. Temperature, carbonator level, overflow detection, etc. They all connect there. Make sure the connection is good and...
Hello I have a watermate that I know works from wiring it up to a standard plug it pumps great etc, My question is hwere on the breakmate do I wire it up to? I...
The watermate hooks up to the the back of the water inlet valve. That way, it only turns the watermate pump on when the valve is open. --Doug ... pos ... open ...
hey doug thanks I emailed you asking about wires on the Inlet vlave as there isnt a black and white wire on the inlet valve and there is only black white and...
I just fired up my breakmate for the first time and ran into a problem. It has an adapter for an external C02 tank. The gas is leaking enough that you can hear...
It sounds like your CO2 pressure might not be high enough. Is it leaking from the little red button near the co2 hookup area? The button should be all the way...
Hi, I had the same problem with my external CO2 tank adapter. The one I have had a bent arm that simulates the bottle and supports the fitting. I wound up...
Curt: Thanks for the help. Is there any easy way to get the arm out? Sean ... <http://rd.yahoo.com/SIG=129fessl5/M=295196.4901138.6071305.3001176/D=groups ... ...
Sean, I think mine just had a big nut that screwed it to the bottom of the fitting. The small gas line just passed through it. Again, I’m guessing a bit at...
Please note that the arm is there for a reason. It prevents the head of the adapter from getting stuck on the black handle when lifting it (and potentially...
Tyler: I do not have a breakmate bottle to try. The red pressure release button seems to be stuck in the in position. I am trying to find some pliers small ...
Sean, I would be interested in hearing where you purchased this external adapter. Unless the bar was bent, it shouldn't be causing this issue. I wonder if the...
Oh, another possibility for both of you is that the little O-ring could be warn and the bar was causing the head to be angled slightly leading to a leak around...
Tyler: It came as part of the machine that I bought on e-bay. The adapter bar was the full length. I had trouble getting it out. All is well now. Thanks for...
Well I bought some machines to just see if I can use them somehow all seems ok But the compressor seems to get really hot on 1 I mean too hot to touch and the...
Hi folks, I have finally received a quote for constructing new, food grade plastic syrup containers that would completely replace the special Breakmate single...
OK Update its normal, talked to a breakmate guy and he said when they first cool down they get extreamly hot( the compressor and the condensor coils......makes...
That was considered, but the vacuum forming only makes a good 3 sided unit, I would need to join two halves together. That's darn impossible in any high...
Hello, Thanks for the update. Yes, I would like to commit to one set of 3 containters. Many thanks again and let me know, -David Hill (650) 302-1133 ...
... hummm good question do you have the paper card that goes in the button panel and just want new stickers to put on top of them? try calling your local coke...
