I HAVE BEEN TRYING TO PUT A BREAKMATE INTO SERVICE. I THOUGHT I FINALLY HAD ALL THE RIGHT PARTS TOGETHER. EXTERNAL CO2, SYRUP, REGULATOR, ETC. WE PLUGGED IT...
Very strange, behind the button panel cover, there are testing procedures, also theirs trouble shooting chart in the photo section of the group. Try those out,...
YES, I HAVE A REPAIR MANUAL. I CAN'T TEST BECAUSE THERE ARE NO LIGHTS ON. WE'VE CHECKED THE OHMS AND CONNECTION TO EACH PART. SEEMS TO HAVE GOOD WIRING. I'M...
can an impeller for a watermate pump be purchased ?? i just got one with a good motor but the impeller (plastic) was stripped out like someone got something...
There is a "pump refurbishment kit" available which basically has the impeller, a new key, some impeller lube, two fat O-rings and a thin O- ring. The kit is...
I have been considering what kind of fountain machine to buy. I have seen the breakmates.. what makes them good and what makes them bad? Does the pop go down...
Well, lets see, the breakmate is the cheapest soda solution, you can machines as low as $200 shipped on ebay. I would get a rebuilt one and not buy it from...
When buying a Breakmate I would pay attention to the cosmetic condition and a warranty on the internal components. Cosmetic condition can be improved with new...
There are a few people trying to make the containers. I am in the process of making them, and should have them available sometime in April. I will be promoting...
Is the an easy way to adjust the amount of co2 in the soda? I have plenty of gas, but the soda comes out flat. In case it matters I am using an external 5 lb...
Sounds like your tank is running low, that would cause a low carbonated soda. I set my regulator to 100psi. Breakmate has an internal regulator set to 75psi. ...
Increasing the carbonation pressure is not an easy task. It involves removing the regulator from the machine. I have never needed to do this for any of my...
I have one and will set it to 100 psi. It didn't seem to matter what I set it at the Co2 content seemed to be the same. Now I have a bigger problem water...
The gray connector is the probe connector. Temperature, carbonator level, overflow detection, etc. They all connect there. Make sure the connection is good and...
Hello I have a watermate that I know works from wiring it up to a standard plug it pumps great etc, My question is hwere on the breakmate do I wire it up to? I...
The watermate hooks up to the the back of the water inlet valve. That way, it only turns the watermate pump on when the valve is open. --Doug ... pos ... open ...
hey doug thanks I emailed you asking about wires on the Inlet vlave as there isnt a black and white wire on the inlet valve and there is only black white and...
I just fired up my breakmate for the first time and ran into a problem. It has an adapter for an external C02 tank. The gas is leaking enough that you can hear...
It sounds like your CO2 pressure might not be high enough. Is it leaking from the little red button near the co2 hookup area? The button should be all the way...
Hi, I had the same problem with my external CO2 tank adapter. The one I have had a bent arm that simulates the bottle and supports the fitting. I wound up...
Curt: Thanks for the help. Is there any easy way to get the arm out? Sean ... <http://rd.yahoo.com/SIG=129fessl5/M=295196.4901138.6071305.3001176/D=groups ... ...
Sean, I think mine just had a big nut that screwed it to the bottom of the fitting. The small gas line just passed through it. Again, I’m guessing a bit at...
Please note that the arm is there for a reason. It prevents the head of the adapter from getting stuck on the black handle when lifting it (and potentially...
