http://loohan.com/88a.jpg
The clearcast base is a mere 11 X 8 X 3 inches in size. Here is the
top of the base before adding the project box.

Then i cut a big hole in the bottom of the project box to feed the
wires through.

http://loohan.com/88bottom.jpg
Here is a section of the bottom side of the base. Note big capacitors
with infinity coil around them. The perf board had a bunch of
electronic components which i later mnostly covered with rocks.
I was guided to glue this rock here and that rock there for days, on
both sides of the board. Also added a few other components, such as a
whole turmeric root, 2 whole cardamom pods, a wad of home-grown tobacco...

Due to the highly compact type of programming being done these days,
the pgm storage capacity of the stones in this unit is immense. And
the rox are maybe 98% filled with programming now, leaving a bit of
space for later embellishments.
The vast majority of the programmming is Arcturan style, but there are
also 2-part pgms as well as a bit of exotic programming from some
friends of Andrea in the Hercules constellation.
And the ice cubes in the box have a lot of reversed-entity pgms. I
will remove these ice cubes as i get new rox to replace them with,
which will probably continue happening on and off for some time.

The epoxy is programmed only with Arct pgms that are not compactable.
Seems foolish now to program resin with pgms that can be squeezed into
a minute piece of crystal. But there are pgms that can't be thus
shrunken. I let the Arcts have free reign, and afterward dowsed that
the epoxy contains 93% of the love pgm in one layer, and 2 more pgms i
haven't identified in the other layers.

Incidentally, i think the way it works to do this pgming is you have
to have 96 chakras, so the Arcts and other members of the Shamanic
Programming Committee (e.g. my higher self and John's) can use these
chakras to translate the programming into worldly rox. And metals.
Metals are good to pgm, even the wires, electronic components, etc.
I think that to some extent, even plastic can take some of the
energy-rectification pgm.

http://loohan.com/88.jpg
Here is the whole unit as it is today after i added the 13 new rox. No
electricity used here. I did not put batteries in the box, so the LEDs
aren't running here. The knobs and jacks are connected to wires that
lead to different internal spots, all carefully dowsed.

The box contains coils (that reminds me, i need to add a little Big
Secret coil today), a couple big capacitors, programmed stones, and
other goodies. Like a small bottle with 2 LEDs that sets on the epoxy
base that is bared at the bottom of the box, such that the LEDs light
up not only the contents of the box, but the base too.