We take delivery of an Amel 54 (Caduceus III) in May 2007 and are in the process of finalising the build specifications. We would be very interested to hear...
... " 7. Has anyone any experience of fitting/using the Probe forward ... Martin: I had Amel install the Interphase TwinScope on my SM2000 Hull # 335 in 2001....
Hi, I have also installed a twinscope in a Maramu, using a hard epoxy mount custom made to make the sensor stand out and see round both sides of the hull, set...
Chuck, Years ago I took my old 38ft. boat with 5 ft.draft across the bar at high tide and I was nervous. I wouldn't think of taking 7ft.across it. you need to...
Hi, We had the Icom M802 (SSB/Ham) and AT-140 tuner installed when we took delivery of SM390 in December 2002. We always felt our transmit range was a little...
Hi John Good to hear from you and thanks for the information. Chuck john martin <symoondog@...> wrote: Chuck, Years ago I took my old 38ft. boat with...
... taken there by here previous owner. The log entries showed it was a good trip, except for a lightning strike. All her sailing instruments were replaced. We...
I'm wondering if anyone can help me with a factoid please, having tried Olivier without response unfortunately. I own Mango 28, built in 1982. It has the...
A friend of mine, who is living aboard his catamaran in the Grenadines, sent me the following story via email: "I have "rich" friends from Switzerland who were...
I havce the same set-up on Tempest, Mango hull 44. I'm having surgery tomorrow, but I'll look it up this week when I visit Tempest in the boatyard. Bob Tempest...
Good luck with the surgery Bob. I'll look forward to hearing from you in a week or two. Sounds like you have a manual to look at, which is more than my luck. ...
One of the rubber boots covering one of the up-down switches built into the Tigress windlass is torn. I am not sure how to get access to this switch and where...
Mark: As you have already discovered, the up-down switches on the Tigress windlass is an Amel installed feature. You access the switches by removing the...
I would like to install a set of Davits on our SM #266. I would sure like to hear from people that have davits installed. Pro or Con let me know!! I saw a...
Tony, I had FKG rigging of Simpson Bay St. Martin install davits. They ran a strut thru the transom to the inner blocking in the aft locker for strength. The...
Tony, Do you have any pictures of the install? Thanks Eric _____ From: amelyachtowners@yahoogroups.com [mailto:amelyachtowners@yahoogroups.com] On Behalf Of...
When turned on, our chain counter politely counts down, or up after pressing the Z, in apparent seconds, completely unaffected by what may be happening at the...
We are persistently getting backflow of waste water through the check valves back into the toilet bowl, enough sometimes to fill the bowl. Besides being ...
Hello Mike, I have a problem with my chain counter too. When at anchor, the reading
slowly counts down, though never up. I have contacted Pochon and they say...
Hi Mike, I have always had the same problem with the forward head only. I have
changed the joker valve several times, but it makes little difference. I am
told...
Hi Ian, Using the high volume flush indeed can improve the character of the backwash into the bowl, however it also significantly limits the number of flushes ...
... built ... gearbox. ... I posted the mechanical drawing of the prop shaft in the pistures section. It appears to be the original drawing from Juin 1977. I...
