Can I use my signalink usb and Winmor to connect to another Winmor station with the same setup or do I have to have different settings for Winmor to work on...
Hello Adam, The SCS PTC-IIex model does not provide radio control. You will need to buy a CI-V adapter to connect the radio to a COM port on the computer, and...
Your IC7000 certainly can be freq controlled from a PC. Have tried with hamlib ? You have a CI-V cable, and you have not altered the default address settings...
hi Adam, ... both is true. the best way is to use the modem as a medium to control the radio by software ;-) What are your settings in Airmail to control the...
I'm a pactor newbie. hav set up airmail and scs IIex w my 7000. using correct cable from farralon. sent my 1st test message successfully yesterday. but I can't...
With the notable exception of AGWPE, which will allow Packet with a PC sound device and interface. It is a "painful" experience however as setup is touchy and...
The mfj-1278 plain doesnt support pactor I, just mfj-1278B model. The firmware upgrade 3.7 adds host mode and few other packet options but not pactor! MFJ-48...
Hello Jean, Werner, Thanks for the information . You are right the freq on the terminal windows shows what you mentioned about. The firmware on my MFJ 1278 is...
Yup. My main interest is VHF packet -- I realize Winmor is mainly an HF-oriented application, if I get it right. Presummably, the SignaLink USB can be made...
Ah-Ha! Obviously, the question, "HOW?" is beyond the scope of this list, but as I (dimly) recall, there were some complications beyond the level of "Plug &...
... My math is wrong but the principle still applies. The carrier should be 2210 Hz lower than the published frequency. See the terminal window. -- Jean-Marie...
... Nitin The MFJ-1278B has it's tones centered on 2210 Hz fixed. So you have to tune your radio 2210 HZ lower than the center frequency of the station you...
hi Nitin, ... what we are missing is the tones setting of your MFJ modem. With an offset of -1500 Hz you are assuming the tones are 1400 / 1600 which is...
Nitin, ... I found a manual of the MFJ 1278B online and it says the modem uses the tones 2125 / 2295 (170 Hz shift instead of the usual 200 Hz) This said the...
Your kidding of course... The Tigertronics Signalink USB is highly recommended for Winmor and at about $100 is hard to beat. Now...didn't you really mean you...
Hello All, I was using a KAM + with my ICOM 745 HF Radio to connect to the VU2GMN PMBO and it was working fine until the day the KAM + packed off. I am now...
Excellent! I shall be awaiting Winmor's release with bated breath! That could mean a huge increase in "membership." - 73 - KW1B ... No virus or malware found...
... it already does. Winmor with the USB soundcards works quite well, better than a PK232 with Pactor 1 in any case. But it is not a plug and play solution. ...
One of my dreams is that the TigerTronics "SignaLink USB" will one day work with Winmor... Now, THAT would make for VERY easy "get-going" for a lot of guys --...
Hi Tim Good advice from Bill. Depending on what you want to do and how fat the budget vs. the butt ;-), you can upgrade if you choose. As stated P1 is slow. I...
I have two PK-232s (updated). Got them for a song and a small bag of seashells a couple of years ago. They work very, very well on all the modes they do:...
Ok. I found out I am missing something. The PK-232MBX that I bought has not been upgraded as I was under the impression it had been. It still has the very...
hi Mark, ... the value of your filter settings is deliberate. You can set it to any value you like. 2.6 was just an example. The filter settings can be seen in...
My goal is not to reset the tracsceiver after using Airmail, but to stop airmail from changing the filter settings at all. Is there a file setting I could...
hi Gordon, ... settings must be adjusted, and from remote nobody can tell you if they are appropriate. But I can give you some tools how you can find out...
When I set up AIRMAIL, the default FSK and PSK settings were 1824 & 2431 respectively. Can someone let me know what setings are appropriate for the FT-857 ? I...
I have all of my equipment connected now. I have Airmail and Packlink installed. I and connect through the internet and send and receive messages there so that...