Can someone tell me what the criteria is for a station being listed in Airmail's PMBO frequency list? Is it tied to RMS Pactor stations listed in the Winlink...
For RMS Pactor (HF Winlink) you will need a TNC capable of Pactor. You can get inexpensive Pactor TNC such as the Kantronics KAM+ or PK-232. I asked the same...
Sound cards have too much processing latency (delay) to handle the ACK/NACK response time required by AMTOR and PACTOR ARQ modes. Find a PK232/MBX, MFJ-1278...
Good question. And it comes up often. Some will tell you "yes" but don't that anything but a "no" for an answer. The timing is to great for a computer and...
Thanks for the fast response. I will pursue a PK232, MFJ 1278 or KAM.  Appreciate your help, and watch out for more questions when I get the HW and SW...
Frank, I have a MFJ 1278B also... I can Connect but it will not TX or RX messages.. Skip... ... From: david_snoddy To: airmail2000@yahoogroups.com Sent:...
Hello david_snoddy, ... Just a note of caution on the MFJ 1278. The MFJ 1278 must be a 1278B or it won't support Pactor 1. 73, Dave I would not recommend the...
I am still learning about this, but I believe the following website is updated weekly: http://users.iafrica.com/z/zs/zs5s/bulls/PMBO.TXT Then the data is copy...
This is probably not going to enlighten you much, but this is what Lee, K0QED, wrote me when I asked him about the difference between PMBO and RMS station...
I believe that PMBO's are a thing of the past. Assuming this is true (if not is will be soon), the official list of active / operational RMS PACTOR stations...
thanks to all that replied but no one really hit the issue. If you use Airmail, as many do, and you update the PMBO list, or RMSP list or whatever acronym you...
Kevin, I think you should probably contact someone on the WL2K staff about updating the ZS5S bulletin. Of course you could just contact ZS5S directly as well....
you e-mail Joost at Joost@... he will change or add things Dave ... From: Eric Christensen To: airmail2000@yahoogroups.com Sent: Monday, July 07, 2008...
All, There has to be someone out there that uses a MFJ1278B with Airmail.. Basic problem is cannot TX any messages... Can connect ok.. But no RX or TX.. post a...
I have emailed the winlink team and did not get an answer. Since it is not my station that is listed improperly I am reluctant to send messages to others...
Skip, I ran into the same issue with my 1278B. As far as I can tell, the 1278 does not support the B2F protocol (at least the 1278 version I have). Some PMBOs...
Hello ng, Hope I won't get banned for putting a OT-question to this group where the use of a pactormodem will be quite common. On board our s/v I use an Icom...
Len Kijk eens op de site van Roel pa0nc (www.pa0nc.nl) daar vind je het programma NCWinPtc dat voldoet volgens mij aan jouw wensen en is eenvoudig te...
C van Hilten
chilten@...
Jul 10, 2008 7:44 pm
3275
Hi, I am still having troubles getting PACTOR to run. I now have an SCS Pactor Pro TNC and both the data and CAT cable to a Yaesu 897d. I've set the offset...
Hello ! Could I have some help with my Airmail installation. I have Firefox internet in my computer, and e-mail is outlook express. Airmail3 worked fine also...
Hi Mark, I don't have a FT-897. Hopefully some one will respond that has one. Before trying to make the radio work with CAT, I would work on just getting the...
... I do not know that error, but have you installed Propagation in it's default location which is "C:" If you installed in "C:\Program Files" you will have...
hi Mark, ... why do you set an offset of 2100? ... center frequency 1500, USB fska and pska amplitude: use high values here (1000 mV) and a low value for DIG...
hi all, ... -- Wills are a dead giveaway. Email powered by Pegasus Mail free at <http://www.pmail.com> Homepage: <http://www.qsl.net/oe9fwv/> Fone +43 5522...
Hi, I have Icom802 with PactorIIusb and Airmail 3.4. I have very limited success rate connecting to the Winlink stations. I use propagation window to select...
hi Zbigniew, where is your location? which BBS's do you try to connect and on which frequencies? do you use the latest BBS list? can you monitor traffic from...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
