I will leave the station set up and on freq, will see if I can see anything. I will be in and out today. 73 Gary WD9DUI From: Leo yudysky Sent: Monday,...
one call KJ4HB, seen... From: WD9DUI Sent: Monday, December 24, 2012 8:19 AM To: V4Protocol@yahoogroups.com Subject: [V4Protocol] Monday I will leave the...
The software is a free download from V4 Protocol in yahooo groups. You have to join the group if i remember rightly and download it from there. Paul KB2VEC ...
Listening 14.073 now... De N4ay ... Listening 14.073 now... De N4ay On Mon, Dec 24, 2012 at 2:34 PM, Paul Harris < kb2vec@... > wrote: The software is...
See a signal but it is weak here on the left coast.... Gary From: Andrew O'Brien Sent: Monday, December 24, 2012 4:57 PM To: V4Protocol@yahoogroups.com ...
All I'm seeing about 380ms on delay with my Flex 3000 when calling CQ. Went through all the stuff in the help files, is there a some sort of magic that you...
I heard you and N6CRR but too much qrm nearby to allow a connect. 73, Dick ... From: WD9DUI To: V4Protocol@yahoogroups.com Sent: Monday, December 24, 2012 8:06...
On my TS480sat, I discovered that there was a vox delay that affected "everything". Digimodes, c.w., and everything. Adjusting that made a big difference. Dave...
Dave Thanks, going to have to sort out a TX/RX delay issue on my Flex lashup. Not sure what is going on, but I'm up in the 350 ms range, which is about 100 ms...
Allow me to share my ignorance. While the TS480 is designed to use (digital) vox for digimodes, some software will also issue a software command to key the ptt...
Heard WB6JFH,N4AY,KF7ONI on 20 meters 22:37 utc. Heard N4AY on 40, Trouble is they couldnt hear me, I ran kit up to 50 watts and had RF freeze computer. ...
Steve, N4AY, We had a good connection there and you had a nice strong s9 clean signal. When you were sending your file after the 6th line we lost connection....
only sig on 40M was NY3J Gary From: Ron Wenig Sent: Monday, December 24, 2012 7:10 PM To: V4Protocol@yahoogroups.com Subject: Re: [V4Protocol] 20 and 40...
I run V4 using my 5000 and have no problem with delay. First off, within PWSDR setup, be sure you set latency to 0. Do this in both the General tab as well...
Paul, I had that problem before too!! What kind of tuner do you have? Do you have ferrite rings on all leads to your computer? I changed out my old tuner , a...
Leo, No ferrite beads just coil wire into air choke, the tuner is a MFJ 945E mobile tuner and the rig is a Yaesu 897D. Antenna is a end fed 24 ft long...
