Dave, You must have the D700 radio in TNC mode (not TNC packet mode) to get the radio to see the GPS input data from the GPS NMEA output string. If you are in...
... Dave, Ditto all the other comments... I don't know what "position digits" to which you refer. (Wrong direction) There is a menu (the real Menu button on...
I have heard it is, but remember that CAP doesn't allow HAM gear on their frequencies anylonger. They are expecting us all to be narrowband complaint very...
This adress may help: http://www.mods.dk/view.php?ArticleId=1505 but I didn't try and I won't try. We do not need it in my Country. A.Tahir DENGIZ , TA2T ... ...
Herb, Richard, Steve, Thanks guys, GPS working fine now on both the TM-D700A and the TH- D7A. A combination of not starting the TNC (duh), and confusing the MY...
MARS very recently stated that MARS must be compliant by 1/1/2008 (if I recall the date correctly.) The D700A is not compliant. Virtually no, if any, VHF ham...
I will be out of the office starting 09/02/2005 and will not return until 09/06/2005. I will respond to your message when I return. The information contained...
FYI ALL... Anyone attempting to use HAM gear for CAP use, I was wrong about the deadline for using it on the band.. DO NOT USE HAM GEAR on CAP frequencies any...
Could you point us to a website where we can read about it? Dick - W6CCD ... From: TMD700A@yahoogroups.com [mailto:TMD700A@yahoogroups.com] On Behalf Of ...
It sure is gonig to cost more start looking for kenwood tk series. Do yu know about the goverment contract with ICOM? Our units can us it. 1Lt. Vonderbeck, Ed...
Amateur gear per se is not prohibited on CAP frequencies. The ham equipment must be NTIA compliant, however, to be used. Virtually no ham VHF and UHF gear is...
... From: TMD700A@yahoogroups.com [mailto:TMD700A@yahoogroups.com]On Behalf Of Ken Brown Sent: Saturday, September 03, 2005 6:08 PM To: TMD700A@yahoogroups.com...
i must have missed the directive. i did not know "ham" gear can not be used to access mars/cap. can someone direct me to the specific ruling? thanks. ...
Sounds to me they are shooting themselves in the foot. Most of us do not have the cash to spend on new or upgraded rigs. My TS-2000 goes to 2.5 vice 5 but not...
Well, I have had the radio a week, an must say that I am impressed with all its capabilities. This is a radio that does EVERYTHING. I only screwed it up to...
When you say it resets, are you loosing all the memorys. My D-700 re-starts when I start the engine, no memory or setup loss. Never had any problems from...
Henry, Do you have the radio turned on when starting your vehicle? If so, the first thing I'd do is advise against it. When starting a car/truck, you'll have a...
I run 4-gauge wire (positive and negative) from the battery to terminal posts under the back seat of my Jeep Grand Cherokee. From there, I run the supplied...
I have my radio wired the exact same way, and have never had this happen. Only diff is I don't have the noise choke, have never observed the need for it. No...
The question is, with these radios with the MPU always on, does it really make any difference? In the olden days, when radios actually turned the power off,...
I have a similar problem except it is just the display that resets -- the audio and receiver continue just fine - only the display blanks and comes back to...
Did you get my earlier information? Apparently, it has not been permitted to use NON COMPLIANT ham gear on CAP since 31 December, 2001. Martin N7HAB/Red Rock...
... Ahhh, yes, the old head "blanking" problem. Have fixed this quite a few times. It has always taken a new connector (RJ-10) on the head end of the cable...
JC, That is a valid point and the only counter I have, is that you're exposing the whole radio the EMF spikes, vs. a small portion of the MPU. 73, Steven ... ...
I have a GM car, and anticipated wiring the 700a direct to the battery to avoid alternator whine - - as had been my experience with other radios and other ...
Is it possible to get a new cable from Kenwood or somewhere else? ... From: TMD700A@yahoogroups.com [mailto:TMD700A@yahoogroups.com]On Behalf Of K8DNE Sent:...
I hope you aren't starting the car with your D700 turned on! There is a potential for a pretty bad spike to happen and this may not just reset your radio, it...
hasan schiers
schiers@...
Sep 5, 2005 5:04 pm
6679
I use a relay. Take power from the battery to the relay com contacts. NO contacts to the radio. The coil is energized from the ignition switch. When the...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
