Gross weight is a bigger limitation for us RV drivers From: RV7A@yahoogroups.com [mailto:RV7A@yahoogroups.com] On Behalf Of Matt Dralle Sent: Tuesday, March...
Sorry, this is not RV building stuff but... I think everyone is getting too much in the weeds. Let's see what happens in the next few months. I agree on...
The leg fairing is centered on the gear leg and on the wheel fairing. I used the Fairings Inc nose wheel piece right in front of the gear leg(where the clamp...
<<RV7 Throttle Mount 002.jpg>> Hi <<RV7 Throttle Mount 003.jpg>> a <<RV7 Throttle Mount 004.jpg>> ll <<RV7 Throttle Mount 006.jpg>> , I have just finished...
My EAA Chapter, 846 at Wadsworth Skypark Airport, will be hosting an Avionics Seminar on Saturday, Sept. 8, 2012. I believe that there might be some folks...
I am about to add electric flaps to my 6a. I would like to see some photographs of the installation. If anyone has any tips I would be grateful. Thanks Jeremy ...
I'll support this for sure, and even go a step farther by eliminating the night restrictions and changing it from day vfr only to (day/night VFR). Kevin To:...
My right gear leg fairing came out pretty good... a minor 1/16" twist which I should be able to get rid of pretty easily. The left side didn't come out so near...
I actually fit it without the intersection fairing. I just test fit it for the picture. The fairing is clamped down pretty tight here. Connected by DROID on...
At this point, I assume you have attached the hinges so it's going to be a little difficult to change. You could remove the hinges and true up the fiberglass...
I would like to thank everyone on the RV7 list for sharing their knowledge and for providing all of the answers that left me baffled. On St Patrick's Day, 17...
The plans say a 1/4" difference = a full deflection of the ball so I do want to get this fixed. (I provided measurements on Letters From Flyover Country ...
I drilled off one side of the hinge this morning after proving the twist with a laser, filled in the holes with epoxy, then i'll attach the hinge with the pin,...
Bonjour, In fact I crash my RV-6 after disconnection of handle of throttle cable.. I recovered and recovered some instrumentations and the engine an IO-360 ...
Am I reading the instructions correctly that there's nothing at the top of the nose gear fairing to secure it other than the intersection fairing that has to...
Bob, The nose gear fairing is in fact only held by the clamp at the bottom and the fairing at the top. I just replaced both pieces as a result of installing an...
Yes, the instructions are correct...and yes there could be chafing on the leg fairing. I built mine per the plans and did not deviate from them. The landing...
I know this isn't strictly on topic, but it is something that has the potential to adversely affect all of us in the USA. I hope you all are aware of the White...
The final count was 3,011 hours and I started on June 30, 2001. It hasn't flown yet; it just got its airworthiness certificate today. I've decided to have...
Congratulations Bob! Been waiting for this a while! A magnificent accomplishment! Enjoy your beautiful machine and stay safe! Fritz ... From: Bob Collins To:...
Design question: Any design and/or building ideas for gust locks with photos? I've seen a few at Oshkosh but really didn't like them. I'm leaning right now...
