I am doing a redesign of the the Micro-Trak AIO, since the commie bastages who make the main switch can't seem to keep them in stock. The next gen board will...
Allen The mtt4 digis that I have, do they output data the same as the standard tt4? I think I finally got my communications problems solved, at least getting...
Russ, They use regular MT-TT4 chips. Do you mean that you can read and write to them from your PC, but they stop working in KISS mode? I am not exactly sure...
Allen yes I can read and write to the digi with my PC and tera-term, change settings and all that, and when 'QUIT', the digi restarts ok yet I don't see any...
Russ, Okay, I may be having a senior moment. You just have a regular MT-TT4, right, not one of the custom units I made in a Pelican case? It sounds like you...
Allen, I have two of the custom mt-tt4 digis with the 8 watt, single freq. transmitter. These are in the small (tt3-AIO) size yellow pelican case. Yes CDMode...
I found 2 posts in the archives describing ways to force a transmission on the MT300 - ground pin 11 (PTT) on the TT3 controller chip (Msg 738), or use the 2nd...
Grounding pin 11 will send a MIC-E position report immediately upon the release of the contact, and it will use the last valid GPS position in memory. If you...
Allen, Â My MT-8000 seems to have ceased working. I have flown my plane twice since the last time it was received on APRS, and the last time I was tracked,...
Searched Google and this forum and read docs... Is the baud rate of the M/T 8000 v 1.2 fixed at 4800 to correspond with the GPS2 puck? I'm testing several GPS...
I'm getting three green LED's followed by one red repeatedly on my new MT8000-FA. GPS puck has logged in (checked via serial), but it is not transmitting. I'm...
The MT-8000 accepts 4800 Baud only, the industry standard NMEA rate. 73, Allen VHS ... From: ve4yz <ve4yz@...> To: MicroTrak@yahoogroups.com Sent: Fri, Aug...
George, A nine volt transistor radio battery does not supply sufficient current to run the MT-8000 FA, and will go into a continuous "reset" mode whenever it...
I do have a special TT3 chip that will work in the MT-8000 (not the 8000 FA) that will handle a 9600 baud GPS. Email me off-list if interested. Byon...
George, Â You also can get a 12V "Industrial Super Heavy Duty" lantern battery at Radio Shack that will work fine. Tom Hunter 805-202-4261 ... From:...
I have 2 6v2.4ah batteries I got at home depot or lowes (used for emergency exit signs) that are rechargeable in series it is 12v and will run the 8000fa for...
The MT-8000 FA can ( heck, it will) be blown up by voltages above 13.2 volts, so if you are going to use the 14.2 volt battery pack array, please use a...
Sorry if this is a duplicate, my last one didn't show up...(if it's moderated, you can ignore this one)... I tried the 8 AA's as suggested (12v), and got a...
Spent some time on this tonight, did the 8 AA batteries at 12 v, I got it to get the solid green light, it does that for about 1.5 minutes, so I assume it is...
Are you able to connect it to a computer and check the setup? Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Kurt...
It does connect, when I try to read/version it works fine...when I try to write it gives Write Failed (code 128 0)...but it seems to have written, when I close...
I agree that the regulator is a must. Any project I do usually also has the "Idiot Diode and Fuse" included to avoid smoke testing on wrong polarity. I know...
Duh, I didn't realize what that enclosure was; not that I don't brush my teeth a couple of times a day. That's what happens when you get old and buy in bulk...
Alright, I've got it sending! I can hear it on my cheapo handheld...but so far it hasn't been picked up by a station (there are one or two in my area)...last...
Gentleman, Been using air born versions of the microtracks for some time with good results N697ms. Ive been trying to get my car unit to work in a high avail...
Mike KJ4GPT wrote... ... N697MS doesn't seem to show up. Was it using that as a tactical callsign, or was it running under KJ4GPT? ... Dunno, but the path of...