I'm trying to loop my amp key line through my LP-100 and I can't get it to work. I've checked the cables and they are fine. I have the alarm setting at 1.5....
Yes, that's a possibility, since the two CAL tables will be in all future firmware, and the ability to switch between them if the 2nd coupler is enabled in the...
Larry, Regarding the older LP-100; is is possible to give us the option of selecting the coupler via a mode option or the VCP program and manually switching...
I had some show pricing for the option, but it hasn't been cast in stone yet, especially for retrofitting older LP-100s. In terms of what it does, it allows...
Hello, I read a few words on http://www.telepostinc.com/lp100.html about this new option. Larry can you write some words about "The dual coupler option"? What...
Larry, Do you have any release dates for new firmware with the utility to read, save, change and recall the calibration data for two sets of couplers? 73, Mike...
I don't think that would be a problem. What power range? Is there any modulation? Would they need a limited mode selection to avoid confusion? Rack mount?...
I work for a pharmaceutical company where I am part of the team that operates and maintains several medium-energy particle accelerators called cyclotrons,...
Just catching up on emails down here at Dayton. No offense taken. I think your probably meant to send this to the SteppIR reflector, though ;-) I am glad for...
I hope that after Dayton, Larry will find time to update the SteppIR VCP to include 80m coil support. Larry's VCP is better fit for me since I use HRD (which...
Hi I hope this post does not offend - if so - moderator please delete... Larry has done a great job with his SteppIR software - but I thought the following...
... No. ... I plan to release a utility to do that after Dayton, where you can read all the data on one page and change/save/recall it. It will actually be two...
I am a new owner of the LP-100a and am trying to figure it all out. Yes I have read the manual. I am wondering............. Does a firmware update require a...
In the link to the manual on the LP-100 web page. The web page is located at http://www.telepostinc.com/lp100.html Here is a direct link to the manual... ...
... It makes me think that it would be great if the LP100A alarm could be based on PWR instead of SWR (or both) so that it would trigger when PWR>X and remove...
There are a number of things that could cause this... 1) As Paul pointed out, they may have their meter set to Fwd Pwr as opposed to the more informative Net...
... showed or what another brand meter showed?" The LP-100 has the ability to display Forward Power or NetPower (FWD-REF). Increases in line SWR will show...
Very close to the bar graph on the Alpha 8100, I dont know how accurate theirs is but it is supposed to be calibrated to their high priced wattmeter. Jim...
Okay guys. I have spoke to several friends on the air who have purchaed the LP-100 and they all said they were putting out more power then what they thought...
