no...didn't break while tightening...the ground wire was sticking straight up..not leaning over to the lug..pretty stiff wire...would have been still at least...
Greetings Group, I have an 82foot AlphaDelta DXCC multiband dipole up about 35feet, strung between two trees. I'm thinking of feeding it with about 50' of...
Your choice of balun ratio is determined by the impedance range you will see. For example if your system presents a 250-1000 ohm impedance the 4:1 will...
Selling my DWM-4 and extra modules on that famous auction site. HF QRO Sensor at http://tinyurl.com/2sdluu VHF/UHF Sensor at http://tinyurl.com/2ugvpk HF...
My AT-100Pro Autotuner has stopped tunning. I have check all antenna connections (including my LDG 4:1 Balun) and all are fine. I am able to tune using my...
pull all power from the tuner, make sure it has no battery back up for field use let it drain for about 1/2 hour then plug it back in set it up and do a full...
If I place the Z-11pro in semi tune mode, will it initiate a tune cycle when I select "tune" from the FT-857D menu (K) if the radio and tuner are connected via...
The Y-ACC cable works in the other direction... Pressing Tune on the Z11 will signal the 857 to send some RF and allow tuning. 857 initiated tuning is limited...
Ok folks here goes: I just got general ticket and am gonna run a ft101E with a gr5v about 50' up. I haven't used a HF radio since my license ran out 30 yrs...
Greg, Pretty much the best choice that you have for your radio and LDG products is the AT-200Pro. It will handle the power of the tube radio since the radio...
The best bet is to always tune into a dummy load, to tune the rig into the tuner, then swith to the antenna, and run the lowest possible output power from the...
I'll second the AT200Pro Greg I've owned both the 200Pro and the AT1000 and of the two preferred the 200Pro operationally. The 200Pro has a little in reserve...
Thanks for quick reply. Would any of the other LDG tuners be ok if I tuned up with my output power cut back to a minimal level; say 10 or so watts? If not I...
Greg, Yes, you could use any of the LDG 100 watt tuners and it would be ok as long as you lower the power to the 25 watt (or lower) range every time you tune. ...
Greg, Yes, you could use any of the LDG 100 watt tuners and it would be ok as long as you lower the power to the 25 watt (or lower) range every time you tune. ...
Mr. Kincaid; you are most helpful. By giving complete answers you are saving me many possible mistakes. I take it you represent LDG. If this is the level of...
Add my voice to those recommending the AT-200pro. My first auto tuner purchase was from another company. Their name also includes three initials, but we'll...
you can also add the link cable from the radio to the tuner so when you hit TUNE, on the radio, the output will go to its lowest setting and use the auto tune ...
Mark, He mentioned that he has an FT-101E. That radio does not have a place to plug a tuner into, so that will not work. For most newer, solid-state radios,...
good point. sorry... Thank you. K4eeZ Moderator of the http://groups.yahoo.com/group/k4eez/ Linking USA and U.K Radio Amateurs Across The Globe Skywarn Id Pin....
Speaking of folding back the power on high SWR, does anyone know if the FT-857D does that? I've got the AT-100Pro connected and haven't been able to find that...
857 does SWR fold back starting somewhere between 1.5:1 and 2:1 SWR. Older models are closer to the 1.5:1 point. I would set (and do on mine) the auto tune...
I sure hope you're not telling me to not buy the 200 pro because it's a bit late. I took your word and went with the 200 pro, bought one today. I think you are...
Hi, I think it will work fine... I have had one in the past on a KWM-2A, With the old tube rigs that you have to tune, remember to tune the radio into a dummy...
... Greg, The AT-200PRO is a great tuner and will work with ANY transmitter once you train it. By this I mean that the 200Pro has freq. sensing memory with 4...
Question - I recently purchased a new LDG AT-1000 Tuner - when the powered on the tuner is off and in by-pass mode, can you operate your amplifier at greater...
Irwin, The RF power limitation for all LDG tuners are for when the tuner is in bypass (or even off) or in operation. Dwayne Kincaid LDG ... powered on the...
I tried to search topics before posting but didn't find any reference to the "problem" I see on my Z11pro when working with my 857. In general, the pair work...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
