Any one have any back ground with pumps? On my v8 conversion i'm running this soob pump externally driven and can go with either sucking the fluid through the...
I think you would want to have the suction side of the pump below the lowest point possible relative to the engine possible so you don't dry run the pump. i.e....
I get that part but what I'm wondering is if it's better to push the coolant into the engine or if it's the same to suck it through or if you are pushing it...
I think it is in from thermostat (bypass)/radiator out of coolant pump directly into the engine. So you are sucking it through the thermostat/radiator first....
In an "in block" installation, the radiator is full and the coolant is equalized level filling the engine block wetting the impeller of the pump. (like priming...
This a center nipple at 1 1/4" and two 1" discharge nipples that got to the water pump nipples of the same size. This is exactlyhow it is stock as far as pump...
I'm just putting back in the stock 1985 to 1990 soob radiator it had when it was a turbo soob. The mounts are still there and I can put it in in a few minutes....
Were going to build the hull for curts craft. We started about ten minutes ago. It will be done tonight or in the early morning. I'm so tired of hearing how...
lol, try working 60 hrs a week, with a wife and 3 little kids, and building alone! You'll see that it'll take a bit longer! :) I am excited to see how fast...
great photos   WWW.SEVTECEXPLORER.COM Make plans to be at the "Northwest Hovercraft Fly In" Aug. 7th,8th,9th 2009   "Other than that, Mrs. Lincoln, how...
Came across this today. I am not sure how the shaft is locked in, maybe just a simple collar on the shaft, but looks like it could be a good salt water pillow...
The t-shirts, coffee mugs, etc. for the 2009 NW HOVER-IN are ready at http://www.cafepress.com/NWHoverIn Pat   For NW Hover-in info & updates go to ...
Anyone know wher rubber molding can be purchased. about ready to start cutting in some side windows and windsheild for the new hovercraft and i dont seem to be...
http://www.griffithrubber.com/ Â http://rubberresource.com/ Â little hovercraft dont need rubbers but for you magnum types this is the real deal. Â ...
Well I'm almost done, I cut about an 1/8" off the right side horizontal brace to move the prop guard to the left because I was getting a prop strike, finished...
Looking good Pat! Bryan Jul 19, 2009 02:53:12 AM, Hoverbuilders@yahoogroups.com wrote: [ Attachment(s) from pat conrad included below] Well I'm almost done, I...
You surely dont want to rush such a big project. perfection is some thing you have to experience over time to really savor. Cant wait to see some pond skimmer...
I'm condsidering building another hovercraft and was wondering if anyone had found a good substitute for 1/8" marine plywood? I want to try something other...
We've always used interior grade plywood, 1/8" but by the time the craft is done it's coated with epoxy on both sides and at least two coats of paint to keep...
Just video tape all the flights what ever you do. I'm more interested in the destruction testing of themes products. Polyethelyne would be very nice. I think...
You're going to be in water, wood rots, foam doesn't. I've got only one small piece of wood on my Scout and that's a half round of Oak doweling on top of my...
Actaul on fresh water wood lasts a long time its the salt water that kills it around here so quickly becuase it gets eatin by the living things and its so...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
