This is a group dedicated to the discussion, use, toolmaking, and ranting about the minimill sold by Grizzly, Harbor Freight, Atlas and whoever else picks up the ball on these little mills.
Please realize that this forum is for exchanging information, bragging about your accomplishments and for asking questions both reasonable and stupid. It is NOT a forum for disrespecting others. Flaming is not allowed here. There is a folder in the files section titled "The Basics". .
Does anyone have any experience with CDCO Machinery, <http://www.cdcotools.com>? I have their catalog and like some of their prices, but have no experience
After spraining my wrist and breaking two DTI's, I was able to finish my mill alignment. (Yep, I have serious problems with my wrists and elbows with pain and
Thanks to Jason Penn for sending me a replacement gear, I am about to get back to work. I have been squaring the mill up again, this time using a digital
I was looking through LMS's new products a couple of weeks ago and came across the Mini Mill Large Table Assy (http://lmscnc.com/3677). According to the