The FT100 Group averages around 150-200 messages per month. Because the volume of messages is rather large, I would like to remind everyone of a few...
FT100@yahoogroups.com
May 1, 2009 8:29 am
31479
try: http://www.burghardt-amateur.com/Burghardt/HTML/new_product_frames/new_text_frame.html Yaesu YP000122 (RA006850C)FT-100 SUB PANEL...
Jeff, Thanks for the great response...I never gave them a thought for parts like that. I just ordered it, and some others. Have a great day! Bill N0RRY...
Check the files in this group . KC6IIH Jock In a message dated 5/2/2009 12:43:14 P.M. Pacific Daylight Time, n1plc@... writes: was just given a bux comm...
Hi all, just bought a ft-100. I have a question about the separation cable. I am going to be using it in a RV and would like to have the option of moving the...
Hello the Group! My FT-100 had the original SRF7043 blown (Without knowing the cause for). Simply one night I turned off my Rig and the day after it had no...
Hi Greg, Yes, it should work OK. I have split my cables and used some 6 pin mini DIN connectors so that I can leave the YSK100 cable connected to the radio but...
Hi, for some unknown reason I lost both of these knobs on my FT-100D... Yaesu tells me they are backordered. Anyone have an old dead control head they want to...
gnd, shield, ptt, audio. A standard yaesu pin out on an eight pin converts to the ad1 male to rj45 modular plug plus there is a cap in the head. 73 - W1JCW ...
Folks, We are heading to Dayton and will be in Booths 114-115. In addition to our W4RT Electronics products, including our Collins filters for Yaesu and ICOM...
... Hi Eric Thanks for that info. I was hoping it would work. It does not look like installing and removing the cable from the body over and over would be good...
Hi Greg, I can't help with a source of the cable but the screws actually go into proper nuts embedded in the plastic. If nothing else, you could probably use...
Greetings! I haven't used my FT-100D for quite a while now, and when I turned it on the display backlight didn't turn on. Looking at the service manual, they...
Have you checked menu 13, the dimmer setting? 73....Eric VK2VE. _____ From: FT100@yahoogroups.com [mailto:FT100@yahoogroups.com] On Behalf Of n9yty Sent:...
I have a problem with my FT 100D, one day put power on and dont have output power.other day discovered that by entering the menu f and move some numbers up in...
hi all im new to to ft-100 and want to do a mobile install with my atas 100 but cant find a seperation kit anywhere due to being discontinued. if anyone has...
I have the mic that came from the factory with my ft-100d. The mic works fine. It is just were the wire goes into the bottom of the mic, in the crinkle cut...
I picked up some shielded cat 6 cable. I will give that a try. Its on the radio itself where I am worried about the treads. I see the threaded inserts on the...
Hi Greg, They are in the radio as well. 73....Eric VK2VE. _____ From: FT100@yahoogroups.com [mailto:FT100@yahoogroups.com] On Behalf Of Greg Sent: Tuesday, 12...
Folks, I have have a number of requests to offer the miniVNA to those unable to attend the Dayton Hamvention at the Hamvention special pricing. We have a small...
Have you tried Yaesu? I got a complete replacement cable from Yaesu(UK) for a mike on another or their radios. It happened because I contacted them for the...
Why not solve your problem with a Heil Headset ?? I use a PRO Set Plus , it comes with both mike elements and works great . The most comfortable head set on...
sounds like the radio is having power problems like many other Ft100's . Check the files on the FT100 site . Jock KC6IIH In a message dated 5/18/2009 5:51:13...
I HAD the same issue with my mic coil too.. Get a can with paint brush included of the 3M liquid tape at home depot and paint it on the coil. It seals it up...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
