Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the FM900 group. File : /CSV2CHL.zip ...
Hi Steve, There is a whole chapter on SELCALL in the Philips FM91 manual that is also relevant to the FM92. Look for the manual can be found in this yahoo...
Hi found the eprom :-) I took it out and read it in my programmer and saved it as my93. I then ran the fpp and selected edit existing order entered my93 and...
Hi Steve, Unfortunately FPP can't read an existing EPROM - you must start from scratch with a new order. That will mean entering the hardware and software...
Hi thanks for info, yes I didn't mdan that FPP read the eprom it was my eprom programmer. The set is brand new never been used and has the test freqs in it,...
Hi Steve, OK, that sounds like a problem with missing FPP master files. Check to see if you have the MASTER files FM93.BIN and FM93S.BIN in the path...
Hi Steve There was a problem with the original FM93 master files, there is an update in the files section here that should overcome this issue filename is...
Hi my names Aaron im fairly new to this group wich has helped me a lot already. I was woundering if anyone could help me by giving me some advice on how to...
Hi you need the service manual to tell you were the various tuning points are. Ideally you need a Signal generator, RF pwr output meter, Deviation meter, etc...
Hi all I have two mid 1989 model FM92's, one is a U bander the other a W1. In order to get the W1 locking up nicely over 70cm's, I had to program it as a T...
This text extracted from the FM91 manual part 1 Page 80 ************************** 1. Switching from OFFSET OFF to OFFSET ON lowers vco frequency_ 2....
Hi Chris, From the table below of VCO frequency ranges for each band you can see that the W1-band VCO is a fair way off 70cm when you swap the Tx and Rx VCOs...
Re: Hi or Low side IF injection question for the group.. Thanks for your comprehensive response Mark Still no success in getting lock on 70 cm's with the...
Try 9265 Plus exactly what the rest of the codes are on your silver plate. VK4TAA - Peter <http://vk4rc.we.net.au/> http://vk4rc.we.net.au/ ... From:...
Hi Chris, I almost agree with Peter. The fourth digit sets head type, channel spacing, and IF frequency. However your original '2' is for a Remote Head, and...
Hi guys Sorry to drag this out but I actually deleted message 6467 from the post list,, or at least I can't see it any more! I resent the post when I noticed...
Hi Chris, That hardware code makes more sense. Philips probably didn't make a 10.7MHz IF in the UHF models, which is why FPP doesn't recognise all the options....
Latest on attempted conversion of 12.5kHz step U bander to 70cm.. Still won't lock with a 12.5 k Channel added !!!! I measured the Voltage on Pin 5 of IC405...
Maybe it's time to try programming it back on the original frequency and check that FPP is working properly and isn't one of the Philips "FPP specials"...
Hello, Its have been a LONG time since I used FPP to make a BIN file for programming a FM900. I have just obtained a Local head FM92 already running on 2m, but...
