Presumably the black and silver ID plate should be correct - you have a FM91 W2 band (500-520MHz) 25 watt radio with a SELCALL module in it for tone selective...
Hi All, I am seeking an FM900 EPROM programmed to 2 metres. Not to fussed about repeaters, need it for simplex 147 and above. The unit is an A Band Remote...
Hi Grant, I have some EPROMs which I programmed some years ago for a swag of FM900s we got up here in VK2. It has all repeaters as well as many simplex...
FM900: Group Rules Note: <this message is sent once a month to all members> 1. No spam 2. No Flames 3. No cross posts, especially non FM900 related 4. Try to...
FM900@yahoogroups.com
Jun 1, 2005 4:09 pm
4999
hence been the problem.I need someone who has the experience to program and service the good old 91.I acutally have 2 of them one fires up and just clicks...
Hello Everyone, Having set up about a dozen or so U band FM92s on 70cm, I am wondering if I have done everything as well as I can. Tuning. With the front end...
Hi Marty The fm91 options are if they are programed in the eprom can be Tx power 1 , 5 , 25 watts eg: Press F then 1 , 2 or 3 if radio is programed with...
Hi, Just wondering if someone can program an eprom for an FM92 to have the CB channels with a scan for Ch 1-8 and Ch 9-40. Also programmed for 25w, and any...
Hi Don, It sounds like you have done the right thing tuning the front end. I sometimes stagger tune the slugs if the receiver needs to cover a wide range....
Possibly a long shot, but I have had some where the 5V regulator is being pulled low and produced low audio and degraded sensitivity, but usually as Mark...
Thanks heaps dan,i new these things were complicated.I suppose for there age ect ect they were state of the art communications. Still today io believe victoria...
Hi Marty, The FPP software runs just fine on any DOS or Windows system with any processor. You may have trouble with the custom Philips EPROM burner and...
... Victoria Police got rid of their FM's years ago. The last of them (VHF models) were removed from service when the CFA and Country Police changed ...
Hi We have loads of VHF and UHF units and cross band repeaters, that have just been decommissioned from our Fire and Police forces but the only snag is we are...
Hi Brian, Would be fairly expensive I imagine, unless someone wants to buy a container load of them :-) I guess too, it would depend on which band they worked...
Hi Marty I use the sunshine eprom programmer but you can get an eprom programmer kit from dicksmiths if you are good with electronics and also do you have the ...
Hi Marty, Be careful that the programmer will work with your PC. Many people have wasted a lot of time and effort trying to make kit and commercial ...
yhanks for that i have s mate who is a store manager of a tricky dickie store.I will give him a buzz now ! Cheers Marty ... programmer kit ... have the ... ...
ok mate thankyou, i will investigate and see what happens. Thankyou again Marty--- In FM900@yahoogroups.com, "Mark HARRISON" <mharrison@b...> ... people have ...
Hi Ian, as far as the scanning goes, you can only have two scan groups of up to 10 channels in each so you won't be able to scan all the channels available on...
Hello, I have an FM900 that is an A band remote head ex Telstra unit. I have progrmmed an EPROM for it and it transmits about 9.5MHZ lower than the programmed...
Hi some ex telstra radios have a littele board fitted to change the tx frequency so the board has to be removed to stop the radio doing a 9.5 mhz split...
That's odd - its the receiver that is 10.7MHz off when the receiver has the older 10.7 MHz IF. Could the radio have a different reference crystal in it - this...
Hello All, I have the opportunity of purchasing an FM92 that is already set up for 70Cm (I am a licensed Amateur), I'm wondering how hard it is to program in...
Warren, You would be better off using two separate radios. Depending on the band of 92 you have, I would be suprised if you would get the vco to lock with ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
