FM900: Group Rules 1. No spam 2. No Flames 3. No cross posts, especially non FM900 related 4. Try to keep content FM900 related. There are groups specifically...
I have an FM92 remote head unit for sale. Set up on UHF CB (25w) with UHF police & SES receive. Installed with CTCSS & Selcall type 1. Comes with DTMF mic,...
Philips Link Interface Unit Especially to suit 814/815's OK, I have never seen one of these, but believe they do exist. Bundaberg Club need one of these, or a...
Do you mean the Philips LIU-3 ? I have a manual if you really get stuck - bought it and the unit from Rockby Electronics in Clayton (Vic) a few years ago. The...
hi Mark Looks like that is what we need - LIU-3 The big question is - where do we get the gear 1st, then we can worry you for the manual. Bill ... From: "Mark...
Have you sold this yet? Also what area are you in? Does it have 468.725? From this you should be able to tell I am in Sydney's North. Thanks Shaun--- In...
Am interested in this unit if it is still available. Have a 92 unit set up for UHF CB but am unsure if it is operating correctly. The red dot appears when I...
Hi, While deleting spam last night I accidentally deleted an email from someone in this group re a radio they had for sale. Could that person please re-email...
Hi all, I am looking for a copy of the Standard channel charts for Victoria, for both the 2m and 70cm bands for the FM92. Also if possible the .bin files for a...
I have one only brand new never fitted A band VCO, It's yours for $25 plus a couple of dollars for post.Cheers Michael ... From: "don2822003"...
michael & bindi
regans@...
Sep 26, 2004 10:00 am
4589
Hi Michael, I am most defiantly interested. Would it be possible for you to send it to me COD Post. This would make it faster in getting here and be the safest...
Hi guys new to the group does anyone have a guide to hex programming a fm900 2764 chip as i have purchased a ett spep plus programmer and just getting into...
I can do this for you in melbourne. E-mail me. Tony ... From: "cfafireman" <cfafireman@...> To: <FM900@yahoogroups.com> Sent: Thursday, September 23,...
Tony
onestop@...
Sep 28, 2004 4:30 am
4592
Hi All Ian All the programing info including the FPP is in the files section of the group along with various documents on using the software to generate a...
Hi all, I have a unit that works perfectly in every way except when a group of channels are programmed into a voting group. It receives the transmission (RX...
Thanks for the sugestion Daniel. The unit is fitted with a CTCSS module (and defined in the hardware code) but it is not enabled in the software code. It is...
double check that on each channel you don't have a code in the ctcss field from an old file that you have modified. i have had trouble in the past with radios...
Yes Aaron, this is a fresh program I wrote specificaly to try to diagnose this problem with various combinations of voting & scaning groups with no Selcall or...
umm, i don't have my manual handy and don't have a radio to open. it is on the same board as the selcall and ctcss modules, right up near the top of the board....
i can't find a pic of the page from the philips manual with the synth board on it. i need to see the top and bottom of the synth board to pin point the link....
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
