Thanks for trying to help - hope the following info will be of use : Nothing has changed the problem is the same using Decoder Pro or the DT400 there are no...
Phil What have you changed, if anything, in the last week or so? Wiring, adding, changing......Computer, replacing, reconfiguring.......anything that got ...
Jeff Have you checked the values in CV5 (V Hi) and CV6 (V Mid) for the decoders in Question? Along with CV2 (Start voltage) you can make a simple speed curve...
Jeff: Besides the speed settings in the decoder did you check the maximum voltage on the DC power pack? It's quite possible that there's just a lot higher...
One other thought. Digitrax decoders have a "switching speed" feature that, when activated, runs the loco at half speed. Could you have inadvertently set this...
Okay Do you see Loconet traffic using Loconet Monitor in DecoderPro? Try changing speed or direction on a Loco and check LM for corresponding changes.....at ...
If you have more than one motor on a decoder what happens with the back EMF speed control ? From: Digitrax@yahoogroups.com [mailto:Digitrax@yahoogroups.com] On...
Off the wall thought here, is it possible for each motor to have a slightly different stall current and if so that may change decoder Requirements??? Also with...
The only modification would be to purchase a DB200! Mike ... From: "jb312855" <jb312855@...> To: <Digitrax@yahoogroups.com> Sent: Sunday, February 01,...
BEMF still works. Each motor will be ideally running at about the same speed, therefore each will make the same back EMF - gws ... [Non-text portions of this...
If want part of the triplex to slip, then adjust the speed table in the part that has the least traction to give that part a little more power, probably in a...
Jason: You're sure you're out of amps? The breaker on the DB150 constantly trips or it just shuts down? If it trips that's one symptom and if it shuts down...
Dear Ken: Do you know what total current is drawn by the three motors when the model is in operation? What is the voltage involved? With three motors you...
Dear Mr. Keddy: Perhaps you have inadverdently configured the decoder into yard mode, In this switching mode power is reduced or cutback slightly for...
I'm new to DCC, sorry for my ignorance. F1 and F2 wires coming out of the DH163 can be used for special lighting effects. I want a mars light and a constant on...
what will happen is BOTH decoders will respond in the way that you programmed them to respond. Better to leave F1 and F2 uncommitted on the motor decoder. If...
Hello, I have checked back in the forum, but was unable to find an answer. I have just hooked up my first BDL168. 11 of the 16 inputs have been used, but only...
if you don't need the green and purple wires on the motor decoder, then just leave them alone. They will respond to commands sent to the sound decoder but...
I was thinking then to map F1 to F11 and F2 to F12 and I would never have a conflict w/sound (F11 and F12 are steam only sounds and my throttles don't have...
Dear Jason: I think you are going to be dissapointed in your quest to get more power out of a STOCK model Digitrax DB 150 command station. I am not saying it...
Group: FX3 decoders do support switching speed on CV 54 (bit 1) So CV-54=1 will allow a function key to turn it off and on... didn't dig that deep to see where...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
