I've seen your site in the past and had forgotten you did the toerails also. It's going to be a labor intensive undertaking since you know all of those bolts...
We have a couple leaks which may or may not be toe rails. we have one scarf joint which could use some attention. I agree it is in pretty decent shape. I...
Hello All:  I had a hellatious freak accident the day before Christmas. I was anchored just out of the ICW south of St Augustine when at around 3AM three...
Send your phone number and best time to call. Joe DeMers Sound Marine Diesel LLC www.soundmarinediesel.com ... From: ira reba To: cal_boats@yahoogroups.com ;...
Reggie, I got a good look at the starboard side where the scarf joint pulled itself away. You're right, it looks a little cruddy but I think it could be fixed...
how old is the boat/shaft? from what material is the old shaft made? what will it cost to have it straghtened, including delivery and pickup, etc? what will it...
Here¹s link to an economical and very helpful company that sells pre-machined high quality prop shafts. May be cheaper and easier than trying to straighten...
since they also do reconditioning (looks inexpensive), perhaps that would be a place to send the shaft. they should be able to give you an opinion on the...
Mike, I looked at your blog about the restoration and it's impressive! I really would love to do something similar with our 2-29, especially refreshing the...
... All these on-line resources are just great. So much planing can be done during the winter months. Two things I have not been able to track down on-line ...
I also scanned and uploaded some of the original cal 2-29 documents/ books I have to my website... The owners manual has a wiring diagram (crude) in it.. ...
A good machine shop can easily and inexpensively straighten a "tweaked" or slightly bent shaft. Ask the local sailors. I had my prop shaft straightened in 1987...
I know that the Cal 29 manual was posted on one of the incarnations of this list at some point. I have a scan of it somewhere, but can't find it on my ...
... I made sure I had drip loops at each end of the wires and used an 8 gauge wire to a buss bar for the negative. That way, the negative side was low...
... Got it last night from one of the sites referenced on this list. Really appreciated it, so pls don't bother with any additional effort. ... Absolutely...
I appreciate the written information and knowledge base on the Cals especially the 29/2-29. It would be great if all the technical drawings and papers could be...
Chris, Catching up on email. Some response comments on my holding tank installation.... Yes ¡ª I was concerned about adding weight to the port side above...
My goal for my website Cal section is to collect pretty much anything I can get my hands on and post for others. This includes any diagrams, books, etc plus...
Wow, what a remarkable resource! Thanks for sharing! I'm finally catching up on all these great emails from you guys over the holiday season and regret not...
Please find the following attached pdfs: Cal 2-29 Mast Spec. Farymann A30 Prop Shaft and Cal 29 Strut. Mark San Pedro Cal 2-29 ... From: Richard Anderson To:...
Hi folks! Let's remember to change the subject title after the initial reply. The above correspondence title would have been logical in the first reply, now it...
  tom the name is buck algonquin and they probably made the original strut they are on th internet and are a great bunch to deal with gene ... From: Tom...
Thanks Mark, I posted those and a bunch of other stuff I found for a large number of Cal models to the site. The prop strut/shaft and mast documents could be...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
