This group allows users of Bruce Chubb's
Computer/Model Railroad Interface
system to share information and solutions. People new to the C/MRI can also learn about
the C/MRI system.
-
This list is operated on the presumption that
posters are willing to study the books and
articles of Dr. Chubb, which are the core of
the system. If you can not study Chubb's
articles and books, list members may not be
able to assist you, as it takes far too long
to repeat the large amount of work aleady done
by Dr. Chubb on a post-at-a-time basis.
-
New member's posts will be approved by the
list moderators. Once it is clear that a new
member is posting on topic (not a spammer)
they will be upgraded to unmoderated posting.
Richard: While I'll stop short of a generic "yes", I am using a single pin on my SMINI nodes to drive multiple LED's (up to 5 per pin), and even 2 tortoise
My question is this, will a CMRI output drive more than one load? I would like to use one output to drive my signals on the layout (LEDs) and the signal
In the model railroading world we often depart from prototype for reasons unique to the task. Our HO club http://www.ida.net/org/pmrhs/index.htm is in the
Bryan, If you check the photos section of this site, under my Selkirk Tower & CP-SK folder you'll see my Interlocking Tower Panel where I chose to use green
But go ahead and add in extra signals, lamps, controls to your liking. I love selling the cards that control them Grin. At the club I used to belong to we had