The ARRL has submitted an interference mitigation plan to the US Department of Defense (DoD) as part of an effort to resolve reported interference from dozens...
NEWINGTON, CT, May 9, 2007 -- North Carolina, Pennsylvania and Oklahoma have -- or soon will have -- Amateur Radio antenna legislation in play. Radio amateurs...
Just a quick note letting everyone know that I made it in one piece, and looking forward to an action packed weekend. The weather today is cloudy and we went...
I hope everyone had a good memorial day weekend and a safe weekend, as for me I spent the weekend at home with my dogs and parrot and two sons, we had a quit...
Dear Affiliated Club Contact: A few weeks ago I sent you an e-mail with an attachment asking for your support in recruiting volunteers as Legislative Action ...
for those that are close to the westland area there is a dinner being held to help the wayne memorial band. spaghetti dinner Friday June 22nd 4:00 – 7:00 At...
The following CBRadioTalk poll is now closed. Here are the final results: POLL QUESTION: Since the weather is starting to turn cold, I would like to possibly...
CBRadioTalk@yahoogrou...
Jun 22, 2007 7:26 am
2618
Quick note from your web master. I have added a BBS oh yea you guys are to young to remember those. A bulletin board system to the web page. you can only get...
i would like to get back on the air again, i have 2 ant.'s, and 2 cb.'s, i can offer much money can some one help me get back on the air, and i have a spare...
Hi everyone. I have a question. I am trying to get another copy of my FCC license and they are asking me: Is the applicant exempt from FCC application fees? Is...
I have connected the C.B directly to the battery and still get the engine noise I only get the engine noise after the van is started it is not from the fuel...
well you have to deturman where the noise is in the power or the antenna system disconnect the antenna and see if you still get the noise if it goes away then...
... antenna system disconnect the antenna and see if you still get the noise if it goes away then you may just end up being able to move the antenna farther...
Another thing you can check, is if you have "resistor" type spark plugs, and "suppressor" wires. Also if any of the connections are corroded. That would cause...
How do I adjust the swr in a mobile I need a refresaher course like ch-1 & ch-40 if high reading at 1 and low reading at 40 do you lengthen or shorten. Allan...
Get a meter. You could end up moving it too much and screw your swr's up even more. Read the instructions on the meter. You set you radio to channel 20, put...
hello i'm nwo 317 i'm a cb op i'm from antigua i'm also ham my call is v21dm i just want you to know that is a lot of thing to get the swr down so when you...
I understand it was low on 1 and high on 40. That's why you use a meter and tune on channel 20. That way you are in the middle and if you get that below a...
BECAUSE IF YOU ARE MAKING THE ANTENNA YOU CAN CUT IT BECAUSE IT WORK ON CH 1 GOOD BUT IT DON'T WORK ON CH 40 SO THAT MEAN THE NEED TO BE CUT BUT AS I SAY I...
Have you been so perturbed at your buddy that you wanted to tell him or her to "go to you know where"? Well, there's a place in Michigan where that's very...
