I have a century fox hydraulic lift for my 1254 tube frame and i was driving it yesterday and my tractor quit andi didn't know why and then i looked at it...
Tecumseh motor blew out 1 inch pipe looking for repair flange: Tecumseh no. 730178A (no longer available from Tecumseh) Anyone know where I could find one?...
Hi - I'm looking for a 2000 RPM rear PTO for the HT series tractors. If you have or know of one for sale, please email me with the info. Thanks, Jeff Werner...
Can any of you guys explain this? I took the head off of the HH160 Single cylinder 16HP Tecumseh engine in my Bolens tractor for several reasons - valve bad,...
Hello all - I was looking for some input as to a Bolens g154 with a 1517 loader on it. Is this a good strong tractor??? I have several Bolens: a 1220 and a...
I am trying to find out what model of tiller I have and can only make out the serial number which is 0400685. The model number appears to be 108? Any help...?...
Hi Hank: ?? Saw your note, I sued to have a small engine repair shop, and the only thing I can think of it the fact that the engine numbers you used were from...
hi Dominic ????? Try online at Sonny's web site.? it is listed under Bolens if you google it? they are in think out in the mid west and they listed a ton of...
Is the question mark key (???????) stuck on your keyboard?????? Every one of your posts is laden with questions marks -- not sure if you are answering people's...
I do not know why that is happening but I will keep an eye on it,? does not appear to be stuck now.? sorry if that was happening I did not mean for that to...
I been collecting IH Cub Cadets and Cub tractors for a year now. I was just offered two tractors one is a Bolens 1053 and the other is a Montgomery Wards...
I have both the larger tire changer and the smaller tire changer. Which one are you talking about? I use the smaller tire changer for the front tires with 8"...
That wisconsin is a strong engine. Verify you get spark, then get a carb kit and go through the fuel system with the objective to get it running. First...
I plan on running it after i get it going. But i'm not sure if i may put a front end loader on it. I need to ask one more question what does that pin in the...
Hi Bill, standing behind the tractor...the pin on the right side hub is called the free wheeling pin. if you ever need to push the tractor you will need to...
Bill, I forgot to point out to you and others....when removing the free wheel pin...DO NOT pry on the hub ! You will only brake off the small tab that holds...
Does anybody know anything about this tractor. Its a 20 Hp kohler two cyl. Its a hydro with cruise control. The tractor had a two speed rear high and low...
I can't say about the tractor but I have an HT-20 w/ 20HP Kohler plus I have a GrassHopper for cutting my lawn and that got a 20 hp Kohler too. I had both of...
Since i'm planning my complete restoration and build up on my 1053 I been wondering about adding weight in the tube frame. I want to fabricate a front end...
1053 isn't hydro, you'll probably need to find a pump to run a FEL. Replacing the tube with solid stock would add some weight. You'd have to drill some holes...
Any weight you can add to the wheels and tires would be an advantage in that it doesn't have to be carried by the axle bearings and all the other supporting ...
I know how the FEL works on the cub cadet 147 hydro and i think the Bolens standard tranny with the hi/low range will work fine with the FEL. The only problem...
Can't answer the bend point of those 3/4 spindles. Might want to consider purchasing new tires if you have the old goodyears, the sidewalls probably aren't up...
