You need to split the tractor to get to the clutch linkage. Tractor service manual covers all the steps you need to do to split the tractor. I have copies of...
Just found this large frame Bolens 1250 still on my trailer. I was told it runs need a battery by the other owner and that the underside of the deck was...
I have a few good used ones also should have all the bearings and stuff for the spindles if needed. Email me at samsbolens@... or contact me thru my ...
I would think that whoever told you that was mistaken...The last I knew the Smog tests were only on vehicles operating on public roads.Do you commute to work...
Which smog test won't it pass? Check your source. It may be they can't sell new ones. There is no smog test for tractors or motorcycles. ... knew the ... ...
I just bought an Eliminator 2000, 20hp Kohler (I believe), the deck seems to be incredibly wide--at least 60 inches, under 700 hours, good condition, not beat...
Thanks Sam, Yuor info was helpful. I got my old tractor running like always. The new still no fire, but all readings on ignition mod is the same on both...
Hi anybody have a throw out bearing for a Bolens H 1704 4x4 diesel and the operating mechanism which goes in the bell housing with two bolts from the back side...
Hi Jim - I can help you with a new throw-out bearing and I think I have the "yoke" you are talking about, but I can send some pics to make sure we are talkign...
I want to say the last one I had to order was around 130.00 or so. You don't need to pull the engine just remove the hood and pull the shield off to get to it....
I'm interested in purchasing a garden tractor for use around my property. Can anyone tell me which of the Bolens models have lockable rear differentials? ...
Hi Mike All of the tube frame bolens (60-70's) have the posi-traction rear. Lockable is not quite right, when in good shape and clean you can vary the amount...
Thanks for the reply Bob. I'm still doing my research. Can you direct me towards a list of which models have which frames. I'm currently looking at two Bolens...
I'm going to be selling my ST160 hydro. It has 771 hours, in good shape. I've welded 2 spots under the seat and replaced the seat w/ non- original. I just...
... In the "files" section of this newsgroup is a "bolens models amd specifications" file that should give you most of what you want. in general however Bolens...
im on the jersey border. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around ...
Hi to all,I'm having a fustrating experience trying to replace the cutting deck in properly suspended working situation under my bolens1050,the linkages which...
Hello all, There must be a virus that is attacking Yahoo email addresses. Many members are sending SPAM messages to our groups and do not know it. If you...
Gentlemen I am instered in geting hooked up with fellows in lower michigan maybe to do some trading of parts .I have a 1050 bolens tractor that i am just...
... From: Mike Richard To: BolensTractorGroup@yahoogroups.com Sent: Tuesday, June 13, 2006 4:42 PM Subject: [BolensTractorGroup] RE: Snow Plow I can get you...
Needs cosmetic work. Runs ok. 36" snowblower 42" mower deck 42" plow blade One set rear turf tires with out rims One set turf tires mounted on rims One set bar...
Hi, I need a flywheel for a Tecumseh engine, for a bolens g14. If anyone has one for sale, please email me, and let me know what you want for it. Thanks, Dale ...
